How to Replace Variable Valve Timing Solenoid (VVT) 2008-2012 Honda Accord 2.4L

Поделиться
HTML-код
  • Опубликовано: 18 янв 2025

Комментарии • 44

  • @TRQ
    @TRQ  2 года назад +2

    √ Watch the Video
    √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
    √ Do it Yourself
    √ Save Money

  • @air-gunners-unite
    @air-gunners-unite 7 месяцев назад +12

    Great video, mine caused a check engine light, as well as limp mode. Not easy putting the bolt back home. But it’s in and no check engine light any more.

  • @jessehill3780
    @jessehill3780 Год назад +13

    Wow first and only channel to realize the VVT solenoid is NOT the same as the VTEC solenoid. So question is if the VVT solenoid is working fine but leaking oil around that area can the seal be purchased on its own?

  • @kevinpulver4027
    @kevinpulver4027 2 года назад +8

    EXCELLENT camera work!
    (I've never seen better, and most is much worse)Thank you!

  • @brandonl562
    @brandonl562 Год назад +5

    Great video. Anybody know the part number for the o-ring on the vvt solenoid?

  • @andrewsexton4521
    @andrewsexton4521 Год назад +2

    how long did it take to do the whole job?

  • @greatjuankenobi217
    @greatjuankenobi217 Год назад +9

    whats the symptoms of a bad vvt solenoid? I have a 2004 acura tsx

  • @chriswilliams9561
    @chriswilliams9561 Год назад +1

    Can I take it out to clean it or do I have to replace it ?

  • @globalprofits101
    @globalprofits101 Год назад +1

    Tell me why your brand looks different like gasket wise and all from the original honda one you pulled out??

  • @BradenBowers-y9f
    @BradenBowers-y9f Год назад +4

    Good video straight and to the point! Thanks for the help

  • @LuisRivera-rw6xz
    @LuisRivera-rw6xz 8 месяцев назад +2

    Damn good video 💯💯 I'm going to try to do my own replacement wish me luck

  • @Robb747
    @Robb747 Год назад +1

    Good job to the tech for not breaking any of them rusted bolts and no wd40

  • @aliz.526
    @aliz.526 2 года назад +1

    Is 2013 same as well? Thanks

  • @dansouza6284
    @dansouza6284 4 месяца назад

    So is this the cam vvt senior not the rocker arm?

  • @s.o.fproductions3871
    @s.o.fproductions3871 Год назад

    One question ? Do I have to erase code for it clear off the dash

  • @pandaguzman664
    @pandaguzman664 Год назад

    There’s no other gasket to replace right? Swap in the new solenoid

  • @Youngflynsaved7
    @Youngflynsaved7 Год назад

    Does the Honda accord 2010 2.4L. lxp model have two v tec seleniods ??

  • @GabrielLopez-fi3tz
    @GabrielLopez-fi3tz 3 месяца назад

    What code did the solenoid throw when faulty?

  • @normanlealao8904
    @normanlealao8904 3 месяца назад

    HELP Please!!!
    I over tightened the bolt and it snapped in half! whats the best way to get the threaded part out?

  • @scotthall8609
    @scotthall8609 5 месяцев назад

    So, my question is, what if the solenoid is stuck... Trying to get mine out of my 2014 Accord (my timing chain cover is leaking) and it will not come out. It rotates a few degrees back and forth but can't get it to budge. Any ideas?

  • @RandomPerson-sb5mw
    @RandomPerson-sb5mw 5 месяцев назад

    is that a sensor or solenoid?

  • @ovr9000
    @ovr9000 Год назад +1

    This video is super helpful. Thanks. I am having a hard time removing the wire. What bent nose pliers did you use?

  • @NJMin231
    @NJMin231 Год назад

    does anyone know if this would be a similar procedure for a 2012 acura tsx 4 cylinder ?
    thanks

  • @musicfashionstyle9269
    @musicfashionstyle9269 Год назад

    What does that help in the car.

  • @tech_irl
    @tech_irl 2 года назад

    I got a P0507 and replaced the throttle body hoping to fix it. The idle stays below 1000 rpm usually, but then sometimes it idles over 1K and sets off the alert again. Could the problem be in this solenoid? The Accord has 150K miles.

  • @TrumpSuperman
    @TrumpSuperman 5 месяцев назад

    Can this fix the cold start rattle

  • @johnmika4579
    @johnmika4579 Год назад

    Does anyone know the factory torque specs what it should be tightened to?

  • @ambertippett1715
    @ambertippett1715 Год назад

    How do you get it out of it breaks?

  • @mayk3lll
    @mayk3lll 2 года назад

    I have a accord euro but my solenoid hits the brake lines from the abs unit. Not enough room to get it out

  • @TheSayed320
    @TheSayed320 9 месяцев назад

    I tok the bolt of but the vvt it wont come out, I tried pulling its rotating but not coming out idk wky

  • @BigROI
    @BigROI 2 года назад

    What year accord is this?

  • @WW-sj7zk
    @WW-sj7zk 11 месяцев назад

    2012 CRV … same motor only that on a CRV there is motor mount that makes this job incredibly frustrating.

  • @erneldoleiva9882
    @erneldoleiva9882 27 дней назад

    The letters do not let you see

  • @reelessential8973
    @reelessential8973 Год назад

    Love your videos

  • @creercreo
    @creercreo Год назад

    Muchas gracias mi amigo. abrazo.

  • @lastof4brothers
    @lastof4brothers 11 месяцев назад

    What you brought out is significantly different from what you put back in. Don't you think you should explain that?

  • @luv4depp
    @luv4depp 2 года назад

    Our solenoid snapped. How do get the snapped part out?

  • @adambentley4006
    @adambentley4006 8 месяцев назад +1

    Mines not that damn easy to pull out

  • @jakesfixes
    @jakesfixes 2 года назад

    Does this fix code p2652? Thanks!

  • @danjones3402
    @danjones3402 2 года назад +1

    The car must be up north with that rust...👀

  • @WW-sj7zk
    @WW-sj7zk 11 месяцев назад +10

    Takes the time to do video but will not reply to any questions. I guess the Honda guys run things a bit differently than Toyota fellas.

  • @SashaNem
    @SashaNem 9 месяцев назад

    thanks

  • @Dieselpwr
    @Dieselpwr 2 года назад

    Its not a sensor

  • @annguyen-venusblinds
    @annguyen-venusblinds 2 года назад

    thanks u