FYI, I think the inlet and outlet are the opposite way around to what you think. Water goes the long way around in the wide spacing. I didnt realise the gasket needed fluid - good to learn.
Having some problems with my 2qm15 no water out exhaust. I changed the elbow which was bunged up. Impeller seems to work as water comes through hose when I turn the engine on. Checked front anode and water seens to be going into the block (or whatever) just not out the top or bypass? Going to test pathways with a hose today but any tips/knowledge would be much appreciated! EDIT: water now not jetting from impeller so will check that today!
The lack of water out could be because of an impeller arm blocking the pipe, or the bearings in the pump housing. You can get a kit on eBay that’s pretty good 🤙
Great Scott ! Only in 1984
FYI, I think the inlet and outlet are the opposite way around to what you think. Water goes the long way around in the wide spacing. I didnt realise the gasket needed fluid - good to learn.
Ah excellent point I hadn’t noticed that 😂
Having some problems with my 2qm15 no water out exhaust. I changed the elbow which was bunged up. Impeller seems to work as water comes through hose when I turn the engine on. Checked front anode and water seens to be going into the block (or whatever) just not out the top or bypass? Going to test pathways with a hose today but any tips/knowledge would be much appreciated! EDIT: water now not jetting from impeller so will check that today!
Ah interesting, check the Thermostat if that’s rotten it be blocking both the bypass and the cooling flow 🤙
The lack of water out could be because of an impeller arm blocking the pipe, or the bearings in the pump housing. You can get a kit on eBay that’s pretty good 🤙
Fits on the flux capacitor ?