📝Hey guys this is a reupload.🔁 If you already watched this video I apologize for that. I was giving myself a hard time with the quality of the videos that I wanted to produce. In the end - I remembered that the audience comes first and GIVING YOU VALUE is the most important thing. I appreciate and love you all! 💚
Hey bro, you haven't had any problems with the graphics card being tight, I want to buy that same graphics card but in 4060 ti you know it's the same size as that graphics card and I have the same case so I ask to see if I wouldn't have a problem? Thank you for reading I would be very grateful if you answer me.
Hey man :) first of all thanks for leaving a comment, I appreciate you a lot! For your question: If you are talking about this 4060TI model: www.asus.com/motherboards-components/graphics-cards/tuf-gaming/tuf-rtx4060ti-o8g-gaming/ It will fit perfectly fine. it is the exact same length as my graphic card (30cm). Important NOTE!: You might need to insert it in a bit of an angle to make it fit so I recommend you to watch again how I did it in the video (minute 28:01) and just be careful - take your time and don't rush it. enjoy your build and if you need any further help - feel free to leave another comment! hope that helps. :)
Usually on the motherboard, you should see connectors next to RAM slots (TOP RIGHT CORNER) or at the bottom where the front panel audio connector is. If you are not sure, check the motherboard manual but note that not all motherboards have this connector, especially if it's like an older system (RGB became standard just a few years ago). Anyway, I would recommend not using the 3-pin RGB connector. It's better to leave this unplugged and control the RGB with the button. Watch from 7:53 to 9:22
I've recently upgraded my system to the following specifications, but I've encountered an issue specifically with RUclips. While streaming videos, I'm experiencing intermittent freezes lasting just a second. Interestingly, the rest of the system remains responsive, and I haven't encountered any similar problems on platforms like Twitch or other streaming services. I've tested multiple browsers including Chrome, Firefox, Brave, and Opera, yet the issue persists across all of them. Any insights or suggestions would be greatly appreciated. System Specifications: - Processor: AMD Ryzen 5 5500 3.6GHz - Motherboard: Gigabyte B550 Gaming X V2 - RAM: Kingston Fury Beast 2x8GB (16GB) 3600MHz - Graphics Card: Sapphire Radeon RX 6600 8GB GDDR6 Mech 2X - Storage: Samsung 980 1TB NVMe M.2 - Power Supply: Be Quiet System Power 10 550W 80+ BRONZE - Case: COUGAR ARCHNON 2 BLACK MESH Looking forward to your assistance!
You mean the one that covers the front 3 fans, witht the mesh? Its easy to take it off but it is a bit scary at first. You hold the case down and you reach below the front panel. It will feel like a handle. Then you just grab and brute force it off. It doesnt have screws, it just clips in and out.
![ЦЫГАНСКИЙ Mid Tower [Cougar MX410 Mesh-G]](http://i.ytimg.com/vi/ygibUhVnEb8/mqdefault.jpg)
![ЦЫГАНСКИЙ Mid Tower [Cougar MX410 Mesh-G]](/img/tr.png)
![Antec AX61 Elite Build Guide [POV]](/img/1.gif)
You are the best I was able to fix the problem with the case fans(they didn't change color)
Glad I could help! :)
You are a legend, I was able to build my PC just using your video. Great work
📝Hey guys this is a reupload.🔁
If you already watched this video I apologize for that.
I was giving myself a hard time with the quality of the videos that I wanted to produce.
In the end - I remembered that the audience comes first and GIVING YOU VALUE is the most important thing.
I appreciate and love you all! 💚
Hey bro, you haven't had any problems with the graphics card being tight, I want to buy that same graphics card but in 4060 ti you know it's the same size as that graphics card and I have the same case so I ask to see if I wouldn't have a problem? Thank you for reading I would be very grateful if you answer me.
Hey man :) first of all thanks for leaving a comment, I appreciate you a lot!
For your question:
If you are talking about this 4060TI model:
www.asus.com/motherboards-components/graphics-cards/tuf-gaming/tuf-rtx4060ti-o8g-gaming/
It will fit perfectly fine. it is the exact same length as my graphic card (30cm).
Important NOTE!:
You might need to insert it in a bit of an angle to make it fit so I recommend you to watch again how I did it in the video (minute 28:01) and just be careful - take your time and don't rush it. enjoy your build and if you need any further help - feel free to leave another comment! hope that helps. :)
@@FullTowerTVThank You so much man
Awesome
I'm glad you liked it 😊
where to put the rgb cable that goes to the mother board (the 3 pins that controls the rgb instead of the button)
Usually on the motherboard, you should see connectors next to RAM slots (TOP RIGHT CORNER) or
at the bottom where the front panel audio connector is.
If you are not sure, check the motherboard manual but note that not all motherboards have this connector, especially if it's like an older system (RGB became standard just a few years ago).
Anyway,
I would recommend not using the 3-pin RGB connector.
It's better to leave this unplugged and control the RGB with the button.
Watch from 7:53 to 9:22
I've recently upgraded my system to the following specifications, but I've encountered an issue specifically with RUclips. While streaming videos, I'm experiencing intermittent freezes lasting just a second. Interestingly, the rest of the system remains responsive, and I haven't encountered any similar problems on platforms like Twitch or other streaming services. I've tested multiple browsers including Chrome, Firefox, Brave, and Opera, yet the issue persists across all of them. Any insights or suggestions would be greatly appreciated.
System Specifications:
- Processor: AMD Ryzen 5 5500 3.6GHz
- Motherboard: Gigabyte B550 Gaming X V2
- RAM: Kingston Fury Beast 2x8GB (16GB) 3600MHz
- Graphics Card: Sapphire Radeon RX 6600 8GB GDDR6 Mech 2X
- Storage: Samsung 980 1TB NVMe M.2
- Power Supply: Be Quiet System Power 10 550W 80+ BRONZE
- Case: COUGAR ARCHNON 2 BLACK MESH
Looking forward to your assistance!
Hey 👋
I am sorry for the late response, are you still experiencing the issue?
@@FullTowerTVyes 😔😔
@@nickthebig can you send me a message on Facebook/Instagram/Twitter? I will try to help you. Just search for @fulltowertv on any platform
can you control fan speed via the bios with the pre-installed fans? ive heard people say they're always at 100%
Unfortunately, because the fans in this case are connected by SATA to the power supply, there is no way to control them through bios/software.
@@FullTowerTVthankyou so much
@@limpets No problem, happy to help :)
how do you take the front panel off?
arrancandolo (no se rompe)
You mean the one that covers the front 3 fans, witht the mesh? Its easy to take it off but it is a bit scary at first. You hold the case down and you reach below the front panel. It will feel like a handle. Then you just grab and brute force it off. It doesnt have screws, it just clips in and out.
Yo bro what radiator are you using cause i will get the same case?
Antec Symphony 240mm
@FullTowerTV thanks bro
И помните: ни слова по-русски, даже на лъосаном русскам 😂
Чел... Тебя на озвучку злобных злых угроз насиональной бизонПасносте 🤣
You are the best I was able to fix the problem with the case fans(they didn't change color)
Glad I could help! :)