Another great video Brent! I just finished setting up mine and measured pushrod lengths. I doubt I'll ever build another FE with any other setup. Thanks for an awesome product and everything you contribute to the world of FE! 🏁🏁
I have not yet returned the block. Good video. I also still will do this in the near future. Will still have questions about installing the valve spring. Open and close spring pressure in combination with the roller cam and the morel lifters. Hope I will be able to start in the next few weeks. Looking forward to wrenching the engine together. Thanks again for your support. Greetings from Germany from Ulf
Prayers for you Brent Thank you for showing all the FE builds I have a mildly built 428 cj in my 68 S code Mustang. It used to be an old drag car back in the late 70s early 80s
Good video Brent, I have some generic PRQ branded shaft rockers for my build. Think I'll fully disassemble and clean any production trash which could be left.
I hate it when I have to put a band aid on the end of my finger, they never fit well! I hope you are feeling better, need to keep you out of the emergency room!
Another great video Brent! I just finished setting up mine and measured pushrod lengths. I doubt I'll ever build another FE with any other setup. Thanks for an awesome product and everything you contribute to the world of FE! 🏁🏁
I have not yet returned the block. Good video. I also still will do this in the near future. Will still have questions about installing the valve spring. Open and close spring pressure in combination with the roller cam and the morel lifters. Hope I will be able to start in the next few weeks. Looking forward to wrenching the engine together. Thanks again for your support. Greetings from Germany from Ulf
Prayers for you Brent Thank you for showing all the FE builds I have a mildly built 428 cj in my 68 S code Mustang. It used to be an old drag car back in the late 70s early 80s
I'll definitely be having these for my 445 when i place my order for parts with you Brent.
Good video Brent, I have some generic PRQ branded shaft rockers for my build. Think I'll fully disassemble and clean any production trash which could be left.
Perfect timing on doing this video. Thanks for doing this. Hope your ticker checks out ok. Sending good vibes to you.
Been enjoying and learning from your videos. Thank you for your expertise and guidance.
Prayers Brent. Get well soon!
Great vedio Brent, keep up the good work,i hope your health gets completely well
Hi Brent, Thanks for the video, Good luck with the health.
What are the numbers on the valve cover lip? Spring installed height?
I hope your health improves! Good video like always..greetings from Argentina
Thank you for sharing your knowledge and skills with us.
very slick Brent. Best of wishes for your good health!
Any ARP lube required on those studs?
Good luck with your health issues. I hate to hear that...🙏🙏🙏
Good luck with your health Brent. Does the rocker shaft kit includes the shims or must one get it additionally?
I hate it when I have to put a band aid on the end of my finger, they never fit well! I hope you are feeling better, need to keep you out of the emergency room!
How do I order this whole set up?
Shoot me an email. Have some in stock.
That’s a way easier way to do that then fighting with the shaft and rockers flopping around on the bench .