I appreciate and acknowledge ur good explanations regarding a faulty torque converter. I have a feeling that could be my problem, the first issue while I was driving I could hear a scra
I heard a soft singing sound between my engine and gearbox/automatic transmission, then it become a bit louder, pls advice if it could be my torque converter,
i have a 2001 mazda famiela sidon car and when it start it rev clean when i put into drive it baffle it struggles and the transmittion does not change no gear at all i only drive into one gear do you think its the turk converter
Trans is slipping in 3rd gear. 1st and 2nd are good and have no lost in pressure so I’m not sure why it’s doing it in 3rd. No cel codes, all shift solenoids tested good and the temp sensor. Even changed the filter and fluid as a last resort. So I have to replace the TC now?
My maruti zen automatic 1997 model needs high rpm initially when i start in the morning after 5 minutes of running everything gets normal. Whats the fault not able to diagnose
Your Maruti Zen’s high RPM on startup could be caused by a few things. It might be due to a problem with the cold start system that helps the engine run smoothly when it's cold. Another possibility is a faulty idle air control valve, which regulates the engine's idle speed. Lastly, the throttle body or sensors might need cleaning or adjusting. Checking these parts should help identify the issue. Good Luck!
Most vehicles do this to warm up the fluids before driving. If it's idling around 1500 RPM and then goes back down to a normal idol after it's warmed up slightly nothing wrong with that.
Yes, bad fuel injectors can affect engine performance and potentially lead to symptoms that may feel like they are putting a load on the transmission. If the injectors are clogged or malfunctioning, they may not deliver the correct amount of fuel, causing the engine to run unevenly or misfire. This can result in bucking or hesitation, especially during acceleration, which can feel like it’s affecting the transmission’s performance. Addressing fuel injector issues can help improve overall engine performance and reduce any related symptoms. Good Luck!
If your 2016 Hyundai Accent makes unusual noises at speeds between 30 km/h and 45 km/h but runs normally afterward, it could be due to worn engine or transmission components, a loose belt, or issues with the exhaust system. Good Luck.
I appreciate and acknowledge ur good explanations regarding a faulty torque converter. I have a feeling that could be my problem, the first issue while I was driving I could hear a scra
I heard a soft singing sound between my engine and gearbox/automatic transmission, then it become a bit louder, pls advice if it could be my torque converter,
You aint getting a good diagnosis in a RUclips comment section use your brain
Thank you so much for the info. My own gearbox make noise when I start the car and I can't run above 30kph without it shooting
Showing a manual transmission gear change for an auto gearbox?
That is just for illustration purposes. Thank you.
i have a 2001 mazda famiela sidon car and when it start it rev clean when i put into drive it baffle it struggles and the transmittion does not change no gear at all i only drive into one gear do you think its the turk converter
Trans is slipping in 3rd gear. 1st and 2nd are good and have no lost in pressure so I’m not sure why it’s doing it in 3rd. No cel codes, all shift solenoids tested good and the temp sensor. Even changed the filter and fluid as a last resort.
So I have to replace the TC now?
clean your valve body one the clutchs are sticking and binding
I didn't know that wiper fluid would also work as transmission fluid.
I won’t try it
Saw the woman adding fluids to 😅
It won’t.
@@samestep7669what a woman 😂is, just a gospel 🥳
My car keeps slow to engage gears, what could be the cause
Well explained 👏
Do you have a shop in the phollipiines to know torque converter problem for my nissan syplhy 2015 model 1.8v.
My maruti zen automatic 1997 model needs high rpm initially when i start in the morning after 5 minutes of running everything gets normal. Whats the fault not able to diagnose
Your Maruti Zen’s high RPM on startup could be caused by a few things. It might be due to a problem with the cold start system that helps the engine run smoothly when it's cold. Another possibility is a faulty idle air control valve, which regulates the engine's idle speed. Lastly, the throttle body or sensors might need cleaning or adjusting. Checking these parts should help identify the issue. Good Luck!
Most vehicles do this to warm up the fluids before driving. If it's idling around 1500 RPM and then goes back down to a normal idol after it's warmed up slightly nothing wrong with that.
2:15 - isn't that a manual transmission stick shift?
my car goes in reverse but feels like neutral in drive , revs but goes no where just really slow, gears not showing on dash but car starts.
hi fix it. can bad fuel injectors put a load on the transmission and cause bucking?
Yes, bad fuel injectors can affect engine performance and potentially lead to symptoms that may feel like they are putting a load on the transmission. If the injectors are clogged or malfunctioning, they may not deliver the correct amount of fuel, causing the engine to run unevenly or misfire. This can result in bucking or hesitation, especially during acceleration, which can feel like it’s affecting the transmission’s performance. Addressing fuel injector issues can help improve overall engine performance and reduce any related symptoms. Good Luck!
sir my car hyundai accent 2016 first moving time 30km to 45km speed time up normal sounds ofter no sounds normal ranig what is the problem
If your 2016 Hyundai Accent makes unusual noises at speeds between 30 km/h and 45 km/h but runs normally afterward, it could be due to worn engine or transmission components, a loose belt, or issues with the exhaust system. Good Luck.
Bro it's transmission overheating not engine overheating engine overheating could be a blown head gasket or clogged radiator
Thank you for sharing.
"Add" 10 hours of labor OR IS 10 Hours?
Lovely
Your pics don't match your description.
5-10 hours to remove a box?
Providing you have a hoist it’s more like 10-15 minutes if you’re taking it easy
You are right. Thank you for commenting.
Then why are the fluids you show putting in and draining are both engine oil, not trans fluid..laf
They are just illustrations for the video. The main ides is the content explaining the issue. Thank you for sharing.
A flex plate is for a manual transmission a fly wheel is automatic
@chase_01 sorry buddy but it's the other way around
So much misinformation 😂😂😂
🥳🥳🥳😮💨😮💨😮💨👌🏻👍
So you gonna give us the right information?
AI generated
Thank you for sharing.
Ai generated stuff always sucks
AI videos😝
Mim pee ach lol
Thanks for commenting.