5 Vehicles For Sale. 1981 Silverado. 1985 IROC-Z. 1988 Chevy Van. 1978 Nova. 1978 Dodge Aspen R/T.
HTML-код
- Опубликовано: 4 окт 2024
- In this video I show 5 vehicles I'm selling after I do a little work on the 1981 Silverado.
Vehicles for sale:
1981 Silverado. $7500
1985 IROC-Z. $6500
1988 Chevy Van. $2500
1978 Nova. $3500
1978 Dodge Aspen R/T. $1500
Dodge parts cars $500 each.
Contact me at clunkersandclassics@gmail.com
Located in Mead, Oklahoma
/ clunkers-and-classics-...
/ clunkers_and_classics
clunkersandclassics@gmail.com
I also have bumper stickers available. $5 to clunkersandclassics@gmail.com on Paypal.com
If you would like to send parts or anything, you can send it here. Much appreciated:
Clunkers and Classics
PO Box 262
Mead, Oklahoma.
73449
Lee thanks for the information of the cars for sale. Well done. Thanks 💯❤️👊👍
I only like Nova's Gen 4, the other stuff you mentioned is not 🚫 at the end of this video I have been watching your videos for years now you are a artist bringing back classics cars 💪🏾I have to salute you for the time,sweats ,and effort into your work salute Sir 😉
Always check the harmonic balancer,, and grab it and shake it up down in out,, my little shake was crank warble,
My brother in laws 86 GMC 350 that was the problem..
That's why the belt was squeaking
You are so right about the AC. ❤❤❤
Hi Lee... that 'contraption' you took off the trans where speedo cable goes is just a little gear box to change the ratio and get a more accurate reading on yer speedometer. Depends on what gears are in rearend , and tire size..... just made speedo more accurate.
.
A guy can only drive so many cars!! Looking forward to the next big build!
How about those aspen lamps in the nova, call me crazy!!
lamps are cracked and falling apart
Like what ya done brother wish I could afford that nova and truck be awesome to have left ve that paint on the truck thank you for the information greatly appreciated.
From everything you've done and explained about the Silverado I believe it needs a new timing set. Other than that keep up the great work
On the truck, pull each plug wire off one at a time and look for the one with no change off or on. Could be rocker too tight holding a valve open.
Good luck selling the fleet, Lee!
Try and replace the harmonic balancer it could have shifted or slid in the rubber and could be out of balance a little bit
Those are internally balanced. Only the 400 was external
Yep, clear some out, get bit more space for the next treasures
You done what many need 80% done minor engine work that done in time
8:48 that pressure valve is there to keep the system primed so you don't crank too much
What is perfectionism it is what is good deals good for right people f themselves good toys cruse make it thier own way good quality products
Put firm prices or you get the tire kickers. That Nova is a super deal
Have you tried to put A T In on that vacuum line and connect both of them into the one?
The Apen rt project with two parts cars and all have titles for 2500 aint bad at all. Someone who is not afraid of a years worth of week ends slaving on it would have a cool car.
Check the harmonic balancer, and the flex plate.
Lee, hope you do well with the sales.
Adjust the rockers
Crank it at night in pitch black dark. And watch for plug wire sparking and a cherry red exhaust tube on head.
That is a back flow preventer on the fuel filter
Wished I lived in Oklahoma
Honestly you deserve it more toys more fun tunes great adventure go eats plus you can say you know cause you built it free them up like wild horses run wild
If any of the valves clearances are too tight on the silverado that will cause a shake on idle.
Hey Lee! Could it be the motor mounts on that Silverado what's causing that shake? I can't recall if you checked them or changed them.
Cheers from Argentina!
could be the tranny mount too
Milk that cow great deals nice stuff good deals pray you get best prices
First thing I would do is switch the Chinese carb to a Quadrajet. 👍🇺🇲
it's had 3 carbs on it. no difference
Definitely disconnect vacuum to charcoal canister
some people dont get it cost time labor shop even after hours some guys side work not cheap plus so many good cheap aftermake ac systems plus copo and napco or na stick with factory to hard find for lot those but ya ease spend try make perfect fuction is better nice deals ya you could buy hood insulation could buy new battieres tires some ones going pull and do it thier way so less is more
If the motor mounts are rubber its hard
That chevy truck got a rocker a little too tight?
Great video. What that old dirt bike across from the r/t. I like bikes and was curious. The vid breifly showed a little of it. Thanks👍👍👍
I don't have any dirt bikes
@@clunkersandclassics my bad. It was a tire or rim from a car I saw.👍
Always a dart in hand lol
Damm it’s a long wheeled base sorry ❤❤❤❤❤
The Aspen is barely a parts car, you should have taken the $500. I wish you luck on the sale of your clunkers.
👍👍👍
if you paint that nova 6 easy 12 all day
Five thousand for the truck
What state are you in? I like the Silverado..
Oklahoma/Texas border
Is Art going to buy the renewed chevelle?
He did buy it. He put a down payment on it
@@clunkersandclassics 👍...I'm almost sorry, because it's nice to glimpse it in your videos
What is the price on the truck?
7500
Where you from
To hear someone say they had just as soon taken the Car to the crusher than to sell a rusted beat up aspin with no motor or tran and interior beat for $500 is a greasy stingysorry person I am unsubscribing
ruclips.net/video/KkQ7r9YbVIY/видео.html
lmao
4000 for truck
stick your 4000 where the sun don't shine
Its the gas nowadays its shit