@sclegalcarry7979 Was the 16 inch pounds of torque you used to tighten the AOS plate to the slide enough to keep it from coming loose after firing? *Meet but do not exceed 25 inch pounds* is what the AOS instructions recommend. I torqued my AOS A12B plate to 16 inch pounds as well. I was just curious to know if you have experienced any issues with using the 16 inch pounds torque spec as I have not tested mine out yet?
Do you know if they will only work with Springfield I got one with my Saint victor but I’d like to put it on one of my handguns but I only have smith and Wesson
Those first two screws that you put into the plate to mount to the gun - are those supposed to be completely flush once screwed in? If I run my finger across the plate, I can feel the rise of those screws slightly. And there's a gap you can see through once placing the optic ontop of the plate because the first two screws are sticking up, pushing on the battery
Mine fit flush. You had to use the screws that came with the plate. The short screws go in the plate. Is it possible you mixed up the screws with the screws that were in with the Dragonfly. They were one thread too long.
I would not use it as home defence or carry gun. The optic turns off after 12 hours. I would buy a Holosun. This optic came with the gun is the only reason I own the dragonfly. Buy I am going to change it to a holosun and sell the dragonfly optic.
@sclegalcarry7979 Was the 16 inch pounds of torque you used to tighten the AOS plate to the slide enough to keep it from coming loose after firing? *Meet but do not exceed 25 inch pounds* is what the AOS instructions recommend. I torqued my AOS A12B plate to 16 inch pounds as well. I was just curious to know if you have experienced any issues with using the 16 inch pounds torque spec as I have not tested mine out yet?
Do you know if they will only work with Springfield I got one with my Saint victor but I’d like to put it on one of my handguns but I only have smith and Wesson
Those first two screws that you put into the plate to mount to the gun - are those supposed to be completely flush once screwed in? If I run my finger across the plate, I can feel the rise of those screws slightly. And there's a gap you can see through once placing the optic ontop of the plate because the first two screws are sticking up, pushing on the battery
Mine fit flush. You had to use the screws that came with the plate. The short screws go in the plate. Is it possible you mixed up the screws with the screws that were in with the Dragonfly. They were one thread too long.
Cut and dry. Nice.
I got the 10mm XDM Elite and my optic was not Mounted either.
Could I mount this on a Taurus G3? I mainly use it as a home defense/range firearm
I would not use it as home defence or carry gun. The optic turns off after 12 hours. I would buy a Holosun. This optic came with the gun is the only reason I own the dragonfly. Buy I am going to change it to a holosun and sell the dragonfly optic.
@@sclegalcarry7979 thank you sir! Will definitely check it out
Hi. Does this Hex red dot site fit on a .45 acp 1911 pistol?
I am not sure.
my top piece did not just drop off like that when I took out the 2 screws
my rear sights appear to also be glued down...making this project much more deifficult
Step 1. Throw it away and get a better optic lol