[34] Ford Transit 350 2021 Van Racking - Part 4 Installing an Inverter and Key Cutting Machine

Disclaimer:
Under no circumstances will Paddy’s DIY be responsible or liable in any way for any content, including but not limited to, any errors or omissions in the content, or for any loss or damage of any kind incurred as a result of any content communicated in this video, whether by Paddy’s DIY or a third party.
In no event shall Paddy’s DIY be liable for any special, indirect or consequential damages or any damages whatsoever resulting from loss of use, data or profits arising out of or in connection with the availability, use or performance of any information communicated in this video. Due to factors beyond the control of Paddy’s DIY, it cannot guarantee against improper use or unauthorized modifications of this information.
Paddy’s DIY assumes no liability for any property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Paddy’s DIY recommends safe practices when performing any do it yourself repairs and or with tools seen or implied in this video. Due to factors beyond the control of Paddy’s DIY, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Paddy’s DIY.
Please like and subscribe. Post a comment and please consider buying me a cup of coffee or a beer by donating with the "Thanks" button :) Thank you!
Hello RUclips friends, and welcome to another wonderful video from Paddy's DIY
In this video I'm continuing to rack out my new Ford Transit 350 van. I'm going to be fitting an inverter and my key cutting machine.
So that's it for this video, stay tuned for the next video in this van racking series, which will be about building a storage unit at the side door.
Thanks for watching. Please Like, Subscribe and Donate if you can!

[@PaddysDiy]

Hey lovely people! Why not buy me a cup of coffee or a beer to say thanks. Click on the THANKS button above 👍☕🍺

[@fergusmccormack6876]

Dont forget to put a grommet round the cables going through the bulk head "as they might cause a short Chafing when the van is moving ,a piece of qualpex piping would do the trick

[@PaddysDiy]

Good idea

[@quickgasservices5223]

Good video, why didnt you use the Customer Connection Point on the side below the drivers seat for connection, would have been lot easier.

[@PaddysDiy]

You learn something new everyday 😀 didn't even know they existed. I'll know for the next time. Cheers

[@aaronbell8527]

Link for inveter mate

[@PaddysDiy]

www.amazon.co.uk/BESTEK-Inverter-Voltage-Converter-Cigarette/dp/B0734RHY64?th=1&psc=1