hello, This spring at second use of the HUSQVARNA Rider R 320 on the lawn after the first two - three starts there was a noise like a scratch (cranck) , we found that the starter motor was detached, the inner casing of one of the two gripping holes was worn out, the screw did not fall anymore. We went to the authorized Husqvarna service on May 14, where the problem was not detected yet. The screw was recharged, the starter motor was removed, the selenoid was changed and the bandix same and at the suggestion of husqvarna staff, we bought a new battery too without any effect. At this moment, the situation is as follows: after two attempts the engine starts then the starter motor gets hot and is no longer able to turn the engine. I write these lines in the idea that maybe you will be able to advise us what to do next to be able to use this machine for as long as possible. Thank you for your patience and attention, Ana Maria ps: i really hope you'll find this massage. Have a nice day!
My John Deere 355D will start but as soon as I let off the key to run position, it instantly dies. Any ideas on that? I have replaced ignition switch and module. Fuel filter and solenoid. I’m stuck...
If you feel confident enough you can remove stuff without breaking it. Play it safe and hook up the water so as to not burn up the seals in the pump, as the motor will be running temporarily on a dry pump. Also on some horizontal shaft honda engines its better to remove the gas tank to access the fuel line rather than the carburetor bolts, due to potentially damaging the gaskets.
Авто/Мото
hello,
This spring at second use of the HUSQVARNA Rider R 320 on the lawn after the first two - three starts there was a noise like a scratch (cranck) , we found that the starter motor was detached, the inner casing of one of the two gripping holes was worn out, the screw did not fall anymore. We went to the authorized Husqvarna service on May 14, where the problem was not detected yet. The screw was recharged, the starter motor was removed, the selenoid was changed and the bandix same and at the suggestion of husqvarna staff, we bought a new battery too without any effect. At this moment, the situation is as follows: after two attempts the engine starts then the starter motor gets hot and is no longer able to turn the engine. I write these lines in the idea that maybe you will be able to advise us what to do next to be able to use this machine for as long as possible.
Thank you for your patience and attention, Ana Maria
ps: i really hope you'll find this massage. Have a nice day!
Ana Ghi maybe the starter needs shims?... (stays stuck)
My John Deere 355D will start but as soon as I let off the key to run position, it instantly dies. Any ideas on that? I have replaced ignition switch and module. Fuel filter and solenoid. I’m stuck...
I have a pressure washer in my garage I would like to try this on. The problem is that I do not own it. Should I try?
If you feel confident enough you can remove stuff without breaking it. Play it safe and hook up the water so as to not burn up the seals in the pump, as the motor will be running temporarily on a dry pump. Also on some horizontal shaft honda engines its better to remove the gas tank to access the fuel line rather than the carburetor bolts, due to potentially damaging the gaskets.
I always try turning it off and back on again.