Re bonding: According to SANS all exposed metal parts of an installation have to be connected to the Consumer Earth. The connections are referred to as Protective Earth, as it is supposed to be independently connected not relying on the Earth from the Utility. Wiki says: The conductor that connects the exposed metallic parts of the consumer's electrical installation is called protective earth (PE; see also: Ground)
Saving setting will not save the assistant file. Assistant have to be saved separately under Assistants tab. Reloading the settings will only amend settings within General, Grid, Inverter, Charger and VS tab.
![Victron VEConfig - General Settings Tab Tutorial [UPDATED 2024]](http://i.ytimg.com/vi/IzixLQ9tSvo/mqdefault.jpg)
![DON'T WASTE YOUR SOLAR - Enable AC-OUT-2 based on BATTERY SOC [UPDATED 2024]](http://i.ytimg.com/vi/sAIRQqOspuo/mqdefault.jpg)
![Victron VEConfig - Inverter Settings Tab Tutorial [UPDATED 2024]](/img/1.gif)
Great Video. Thanks for sharing
Re bonding: According to SANS all exposed metal parts of an installation have to be connected to the Consumer Earth.
The connections are referred to as Protective Earth, as it is supposed to be independently connected not relying on the Earth from the Utility.
Wiki says: The conductor that connects the exposed metallic parts of the consumer's electrical installation is called protective earth (PE; see also: Ground)
Thanks for extra info
Great Video.If you are using 3 inverters in an ongrid system, why will your inverters switch off if 1 phase from grid side is dropped ?
Great Video!! i just have one question about ground relay, You config only for the master for each Phase? Thanks in Advance
Thanks for watching, I'm glad you enjoyed it. All settings from the Grid to the Charger tab are carried over from the Master to the Slave units
Saving setting will not save the assistant file.
Assistant have to be saved separately under Assistants tab.
Reloading the settings will only amend settings within General, Grid, Inverter, Charger and VS tab.