I ordered a new upper control arm that came with the ball joint and rubber bushing on the sides. My issue is the large 22mm nuts and very large washer came very lose from supplier. So my concern is how many pounds should the nut with large washer be torqued to.
my repair manual says not to change the upper balljoint, but change the whole control arm. is it safe to change the balljoint only? the control arm is good , not rusted
Nobody explains stuff this good anymore thanks man
I ordered a new upper control arm that came with the ball joint and rubber bushing on the sides. My issue is the large 22mm nuts and very large washer came very lose from supplier. So my concern is how many pounds should the nut with large washer be torqued to.
my repair manual says not to change the upper balljoint, but change the whole control arm. is it safe to change the balljoint only? the control arm is good , not rusted
Mucho bueno compadre... New subscriber here .✌️
Beautiful work!!!!
Good job! I wimped out and just bought the whole upper.
Same here
That's because you're smarter than this guy.
Where does the snap ring go?
How long does it take?
It takes....whatever it takes.
I needed to know how to get around that damn break line
Cut your wrench in half... it is a tough one. But I have cut the wrench before to make it work, thanks for watching!
Thanks a Million
The 2 nuts are 21mm not 17 or 18mm and you shouldn't hit aluminum with a hammer it can cause damage to it
What about a rubber mallet?
Muy bueno yo lo voy a ser