01-03 gsxr 600 750 aftermarket ignition how too
HTML-код
- Опубликовано: 7 сен 2024
- I couldn't find any clear or informative info on a ebay ignition switch. Putting the resister on is easy, realizing the way it comes wired is another story. not one video went over the misplaced wire connector. So here ya go. Your welcome. if it helped you please like
Bloody hell, I was just about to spend $300 on an ECU when I stumbled across this. The wire swap fixed the dead "ON" switch and the resistor fixed the no spark. This was the exact fix, in my case. And yeah, it was a $55 set from Ebay that looked perfect, gas cap and seat lock included, but no bueno on startup.
Dude... you. Are. The most amazing human on earth. I've been searching for HOURS on how to do this and there wasn't a single video or single thread with good detail and no one knew when I asked. I randomly found your video after searching for the 1000th time today after scrolling for hours and your video helped me in minutes.... you my friend do not have enough likes. If it's ok with you I will be posting this om reddit and Facebook groups and everywhere I can so hopefully you get the recognition you deserve. Thanks so much man. Wow.
Why thank you. I was in the same boat so I made a video since there wasn't a single one out there for this bike. I appreciate you
So my bike got stolen luckily that the piece that was still attached the aftermarket one didn’t work so I just put old internals in new one!
If you don’t swap red and orange wire you won’t get any spark?
Hey just seen your video and I have a question , does the red wire from the ignition switch run directly to the main fuse relay? Or is my wiring wrong on the ignition side ?
The Red wire comes from the battery ,,yes from a fuse
Wil this work on my gsxr 600 2001?? Because my stock ignition switch when on is red and orange have continuity then orange/yellow and black/white have continuity and then Grey/brown have continuity but in this ebay switch i only got continuity on BR/W and O and R and R/W i dont have continuity on the B and B/W wire when its turn on
Can you please confirm it if it will work on my gsxr 600 2001 when put it in even i dont have continuity on B and B/W wire but my stock wirings its should have continuity O/Y and B/W
So I bought a new ignition from Amazon for my GSXR 750 2007 and the plug end of the ignition does not connect together . So knowing my ignition that was in before worked I put it back in and there is now none whatsoever lights on the cluster no anything showing it powered on I don’t know what the heck
Did you ever find out what happened going through this right now and stuck
What resistor is it? Can i just buy on the electronics?
That sucks ..the later models can just swap that harness part out with the old one it's same design
Man i did everything you said and its still not working 2005 suzuki katana 750 please help
This is for a 01-03 gsxr. Katana is probably a different lock cylinder but basically the same but colors may be different
What size is the resister?
100 ohm .5 watt 5% tolerance