See if you can spot the error when connecting the negative wires to the bus bar... I did something redundant... I will post the updated schematic to my website as soon as I have it done. Enjoy!
Thanks. Because the high amps that the buck (dc to dc) converter could potentially draw. I do not like running high current through these types of switches, although they say they can handle 20A.. they tend to heat up. Thanks for watching
@kaput808 but another reason is if you had the load far from the switch, you could use a smaller guage wire to operate the relay located near the load. Smaller guage wire = cheaper :)
See if you can spot the error when connecting the negative wires to the bus bar... I did something redundant...
I will post the updated schematic to my website as soon as I have it done. Enjoy!
Was the redundancy the second neg relay hookup? You have them jumped i think.
Yes, you got it. I fixed it later on. Good eye.
What is the purpose of the relays? Arent they just fancy switches?
I really enjoyed this build video
Thanks. Because the high amps that the buck (dc to dc) converter could potentially draw. I do not like running high current through these types of switches, although they say they can handle 20A.. they tend to heat up. Thanks for watching
@@natesdiysolar ah ok. Good to know
@kaput808 but another reason is if you had the load far from the switch, you could use a smaller guage wire to operate the relay located near the load. Smaller guage wire = cheaper :)
👍 P R O M O S M