60 Series Flywheel housing Front Cover and Bull gear

Поделиться
HTML-код
  • Опубликовано: 5 окт 2020
  • Detroit Diesel 60 Series Front cover and Flywheel housing install

Комментарии • 13

  • @notchfox6086
    @notchfox6086 Год назад +1

    Thanks for sharing! Very helpful video!

  • @josedejesusflorespliego9273
    @josedejesusflorespliego9273 2 года назад +1

    Thanks for sharing!!! Very good video!!!

  • @littled6698
    @littled6698 Год назад

    For aligning the case, couldn't you get the case on there with the bolts in, and then fit the bullgear in place, tighten case bolts and then pull the bullgear off?

  • @santanatruckingco
    @santanatruckingco 4 месяца назад

    How did you get the idler gear in there after installing the bullgeae 😮.

  • @rogerluenebrink3156
    @rogerluenebrink3156 2 года назад

    Ok nu.ber one cylinder just in front of it.there is a little detent I have oil pouring out of it what's the fix and need part number it probably o ring

  • @charliesmall4685
    @charliesmall4685 3 года назад

    What happened with your video when you put bull gear cover on it cut off

  • @marcosdiesel6012
    @marcosdiesel6012 2 года назад +1

    What city is your office in?

  • @njtransportllc
    @njtransportllc 3 года назад +1

    Hey whats the part number on that sealant???

    • @PickupsAreNotTrucks
      @PickupsAreNotTrucks 2 года назад

      Detroit Diesel makes their own. It comes in a caulking tube just like this. Part number is 23514188. Hard to find sometimes but your best bet is the local Detroit parts shop. It’s $100 a tube. I wouldn’t risk using anything else, personally.

  • @firsttimediesels6289
    @firsttimediesels6289 Год назад

    So, i didnt use that plug for the front cover because work doesn't have it. Now i bar the motor over and it just stops. Take the overheads off and it moves again. Valves hitting pistons. Could the crank be 360°off

    • @0698gingerich
      @0698gingerich  Год назад

      If the didn't get the cam dowel lined up with the cam gear it will push into the cam. Not sure but have seen it happen

    • @0698gingerich
      @0698gingerich  Год назад

      Can't type. But if the cam gear isn't lined up right the dowel will push into the cam and you won't know until you turn it over.

    • @firsttimediesels6289
      @firsttimediesels6289 Год назад

      Got it turned over today, cam needed to be turned to match crank. Rookie mistake but I'm worried about the lash adjustment because I didn't use the alignment plug because work didn't have it. Will find out tomorrow