How To Replace Front Shocks 1998-2011 Ford Ranger
HTML-код
- Опубликовано: 11 окт 2024
- This video will show you how to replace the front shocks in a 1998-2011 Ford Ranger pickup truck.
This is an easy do-it-yourself repair that can be performed with simple hand tools.
#fordranger
#autorepair
#diy
Buy Replacement Shocks in our Amazon Store: amzn.to/2ZAra4R
Disclaimer
Our videos are for entertainment purposes only. It is recommended that you seek advice or help from a qualified professional while attempting any and all repairs.
Do-it-yourself repairs can involve risk and injury, we assume no responsibility or liability for losses, damages or injuries that include but are not limited to direct, indirect, special, incidental, actual, consequential or punitive. All repairs performed by our viewers are at your own risk.
While we do review products that we use daily or have even used for years, we also review and test products for companies that have compensated us to try their product out. We are independently owned, the opinions expressed are our own from personal experience while using any and all products.
We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites. Recommended products with links may be commission based when products are purchased from them.
Buy Replacement Shocks in our Amazon Store: amzn.to/2ZAra4R
Wonderful video! I didn’t think it was that easy, thank you!
You’re welcome 😊
So compressing the springs is not needed apparently...I have a 2000 Ranger 2.5L and planning to do the same! Thanks for the video.
Glad this helped you out
I find if you jack up the front end of a few feet remove the front tire you can put vice grips to hold the very top of shock to stop from spinning and stick a open end wrench to remove the nut make sure you spray all nuts and bolts with penetrating oil.
Thanks for watching Anthony and the added tip!
Just the video I needed to see. Unfortunately I had to do the same. I had to actually burn through my boot I'm not going to reuse it. Put a couple holes in the top plate so I can stick a screwdriver in there, so as it turned it had something to catch on, I guess it was so rusted that it ended up breaking the thread anyways, saved me a lot of unscrewing. 😂
Thank you for watching our auto repair video that shows you how to replace the shocks on a Ford Ranger. Hope it helped you out.
Can you do this with just a jack? No lift
Yes you could do it on jack stands.
Any way to get the top nut off without snapping it or using a sawzaw? Hoping to re use the shocks but the top nut is super stuck and the shaft is just spinning like yours was.
You could try some penetrating oil, but a lot of times they are a pain to remove.
@@HomeOwnerRepair yeah I tried using a torch to heat it up after I tried some pb blast and let it soak. Neither worked so I just used a deep socket and a breaker bar to snap it off. It was all basically fused together so I just bit the bullet and got new shocks. Not even going to waste the time or fuel on the other one and just snap it off right away tomorrow. Thank you for replying though!
Is the shit leaking radiator fluid
Not sure it may have been
You say, "This is an easy do-it-yourself repair that can be performed with simple hand tools." Do you think we all own an air compressor, impact wrench and sawsall? Those are expensive power tools and an air compressor is very expensive. I am not going to buy power tools or an air compressor. My 2 wheel drive 2003 Ford Ranger Edge has torsion bars not coil springs. So you video was of no help to me.
John, You do not need an air compressor or impact gun to do this job. It can all be done with simple hand tools.
If you don't have air/power tools you use a ratchet and a hacksaw. If you can't figure that out you probably shouldn't be working on a vehicle in the first place.
You should probably have those things handy if you're driving a truck ... but I get that you can't always afford those things in a pinch. Check out Facebook marketplace if you or someone you know has one n
You own a truck but no power tools? You own the truck for looks?