ANGLE FINDER by General TOOLS REVIEW

Поделиться
HTML-код
  • Опубликовано: 6 окт 2024
  • ANGLE FINDER by General TOOLS REVIEW
    Support channel with PAYPAL donation: youtubeInfluencer@outlook.com
    BUY Digital Angle Finder HERE! Amazon Link: amzn.to/3pe1L2m
    BUY COMAN KX3636 Tripod HERE! Amazon Link: amzn.to/3dIAv64
    BUY Panasonic HC-X1500 4K Camcorder HERE! Amazon Link: amzn.to/3QCUy4f
    BUY HC-V180K Full HD Camcorder HERE! Amazon Link: amzn.to/3ewA7nP
    GoPro HERO10 Black HERE! Amazon Item link: amzn.to/3Cedq55
    Buy Panasonic 4K Camcorder HC-WXF991K HERE! Amazon Link: amzn.to/3PuXL4n
    CyberLink PowerDirector 20 HERE! Amazon Link: amzn.to/3dELRrq
    BUY Sony FDRAX53/B 4K Camcorder HERE! Amazon Link: amzn.to/3AukDNh
    Buy Viltrox Lighting HERE! Amazon Link: amzn.to/2MW1FpH
    Buy Sony Cyber‑Shot RX10 IV HERE! Amazon Link: amzn.to/3QEsJZy
    Buy Sennheiser MKE 400 Shotgun Microphone HERE! Amazon Link: amzn.to/3c3jrqE
    Store Link: www.amazon.com...

Комментарии • 5

  • @monalisahota
    @monalisahota Год назад

    Very fun review. Loved the narration

  • @donf3739
    @donf3739 2 года назад

    "Rev" (Reverse) flips the reading to the opposite side of the protractor. In other words, if it reads 0 and you hit Rev, it will read 180. or 10, rev, 170, etc.
    Good luck finding instructions. I couldn't find any. That's why I went to RUclips.
    Annnnnnd mine doesn't have an "Off" button either, but I timed it, and it shut itself off at 5 minutes.

  • @TheJu2ber
    @TheJu2ber 10 месяцев назад

    how do you turn it off? Mine stays on and never turns off. I have tried holding the on button, hitting it twice, nothing seems to turn it off unless you take out the battery.

    • @LEARNINGCHORDS
      @LEARNINGCHORDS  9 месяцев назад

      same here.. u would think you could just press the button but i also do what you are doing

  • @dandexinventor
    @dandexinventor Год назад

    How did your Jewish Star turn out?
    I did make one about 20 years ago when I bought a new table saw and wanted to see how accurate the miter gauge it came with was.
    I made two triangles then layed one on the other and xfer'd the lines where they overlapped. I cut the overlapped pieces out and glued everything together.