Stihl 024 AV Chainsaw Carb and Impulse Line Replacement
HTML-код
- Опубликовано: 21 окт 2024
- Stihl 024 AV would not start. The carb probably needed new gaskets, or the impulse line had a small hole/crack. I replaced both. This fixed the starting issue and the chainsaw now works great!
Disclaimer: Due to factors beyond the control of this video and/or RUclips channel In-depth DIY, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. In-depth DIY assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. In-depth DIY recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of this channel, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained.
i know this is a year old vid but i cant help sending you a suggestion or 2. first the fuel line is in backwards second there are 2 ways to take that throttle linkage out, the easiest is to take the one screw out of the back of the handle and taking it off, the other is to roll the throttle lever down and use a small screw driver to drop the linkage off the arm in a down ward motion.
The 024/026 doesn't call for a intake or carburetor gasket. It probably won't hurt but it's not necessary.
Your fuel line is backwards. The part you have hooked to the carb should be inside the tank.
Your fuel line is installed upside down. The "s" bend goes in the tank.
Take the screw out of the bottom of the handle remove the black cover, disconnect the linkage at the handle end and you don't have to wrestle with the linkage.
Hello...justement voici mon problème ....La tringle d'accélérateur ! !pas trouvé pour démonté le couvercle de poignée et de raccrocher la tringle sur le carburateur. ..Merci à bientôt
En français impec!
Took the words right out of my mouth
It would have just been easier to take the saw apart.then you can go in and clean your saw up and check other things as well but I noticed on your video you didn't show that you hooked up the in pulse line in the back you threw it all together and I watched the video twice.
Thank you. Very well done explanation and video. I did not want to take all apart to replace the impulse tube. Thank you
Geez! Take a look at that air filter! Most of the flocking's gone! Seen that before where someone took a wire brush to it thinking it was dirty. If you use that it'll ingest dirt!
When removing throttle linkage. Open throttle then put a screw driver into and under the butterfly to hold it open then release the throttle and it will fall off!
Thank you
Should be felt on the air cleaner looks like someone scraped it all off with a wire brush
Yeah that air filter is shot. I guess it will keep a log from getting sucked into the carb.
that damn throttle clip is a bish isnt it lol
It can be!
I take the handle apart it takes 30 seconds , Its a lot better
Rob
NSW
Australia
It's like watching a gorilla do open heart surgery! Just take the cover off, it only takes 30 seconds.
Why did you replace the impulse line? I have a 042 But I just put a carb kit in and fuel is leaking out from somewhere and making the saw stall and flood could this be why or is it most likely maybe the needle and seat?
Thank you for this vid. :)
Do you have a parts link?