Good music, nice video. Especially when you use a tweezers to push the small tube in and a nail and pliers to hammer it in place. Fantastic misuse of tools.
Nice job! I can't wait to try it out myself. What kind of paper did you use to transfer the traces to the copper? Did you use water or alcohol to dissolve the paper?
Step 1: Sand all the copper off...
Step 2: Get a new board.
Step 3: Start over.
Good music, nice video. Especially when you use a tweezers to push the small tube in and a nail and pliers to hammer it in place. Fantastic misuse of tools.
Why not simply use a thin wire and solder top and bottom? Why waste money to buy those via?
Nice job! I can't wait to try it out myself.
What kind of paper did you use to transfer the traces to the copper? Did you use water or alcohol to dissolve the paper?
Excellent
Nice video Excellent 👌
18:53 trace is incomplete
Looks like SMT transistor pads to me
ferric chloride and no gloves? you really like living life on the edge, huh?
What type of paper did you use?
Excellent Job!!!
to wash down the tonner is better to use aceton, otherwise realy nice. I can't wait to try it by my self
Great tip!
where can i buy vias screw ?
you can buy them on ebay or aliexpress
@@InvertLogic what's the name of them?
@@ahmed.waleed91 just search for "PCB vias" on Aliexpress
@@InvertLogic thank you ♥
www.aliexpress.com/item/32841223798.html?spm=a2g0s.9042311.0.0.184d4c4d5HN6QH
they are called Hollow Rivet Double-sided Circuit Board.
👍👍👍