- We appreciate your Support and Purchases! - Replacement 2.0t TSI/FSI DV www.shopdap.com/oem-diverter-valve-dv-2-0-t-06h145710d.html DV Mounting Bolts www.shopdap.com/n-105-464-04.html
Super helpful. Just replaced the diverter valve on our B7 avant today and it fixed my P0299 code! Best tools for me were 1/4 inch ratchet, 1/4 inch 5mm hex bit socket, and 3” 1/4 inch extension. Every other tool was either too long or got in the way. Take your time and be patient and it’s an easy swap.
Never a routine job. There is always some one new (me) who gets a lot out of these vids. It did help having the extensions to see exactly what is going on. Didn't expect to find under the car - but the engineer probably got a good laugh out of it. Over all thanks for helping out with this information. Thanks.
Thanks Guy's... Just did a new valve plus the GFB DV+ Kit on our MK6 GTI. Connector Plug was a bit stubborn but we got it. Very pleased with our efforts.
I changed this valve this year. It was leaking small amount of oil It leaked for 4 years. Small amounts... Finally I was able to change it. Much clean back there now..
Just watched the vid. Excellent camera placement. Great vid except at the end just before you appear to say finished you will notice that the 5 mm allen tool is still on diverter fastener!
You should post one of these videos for 2020 VW Passat se installing the DV+. not too much info out there because the job requires access from underneath.
@@kkelv I know it's been 3 years but you push back on the little tab while pulling the connector in the other direction. Try with your hand before using a screwdriver, more prone to breaking. Good luck lol
Thanks for the vid. I have a 2012 Jetta GLI/tsi 2.0t . I purchased the valve part number 06h145710d. Is this the right part? The harness seems different.
So it looks like there is some sort of plate over where the location is shown in this video. There is however an identical looking part up by the right hand side of the front grill that is attached a large air hose, attached to the plastic turbo Inlet pipe, any ideas what's happening here?
Would this fix a low compression problem on cylinder 3 on the 2.0T FSI engine? If not, what are the obvious suspects? Valve issues, etc? What's the typical cost to have a valve job done on this engine? Thanks, Mark
Wondering if this is the same part we need? We have a 2014 VW Jetta, Trouble code P0045 Turbocharger / Supercharger Boost control solenoid A Circuit/ Open Your time is greatly appreciated.
The old valves with a bellows type diverter rip and leak boost to atmosphere, they changed the design to a piston which is more robust than a rubber bellows.
I've been trying to change it on my car, but I don't have the ability to lift the car up. Let me tell you how much of a pain in the ass it is to even lift it up.
- We appreciate your Support and Purchases! -
Replacement 2.0t TSI/FSI DV
www.shopdap.com/oem-diverter-valve-dv-2-0-t-06h145710d.html
DV Mounting Bolts
www.shopdap.com/n-105-464-04.html
Super helpful. Just replaced the diverter valve on our B7 avant today and it fixed my P0299 code! Best tools for me were 1/4 inch ratchet, 1/4 inch 5mm hex bit socket, and 3” 1/4 inch extension. Every other tool was either too long or got in the way. Take your time and be patient and it’s an easy swap.
Never a routine job. There is always some one new (me) who gets a lot out of these vids. It did help having the extensions to see exactly what is going on. Didn't expect to find under the car - but the engineer probably got a good laugh out of it. Over all thanks for helping out with this information.
Thanks.
Thank you needed to know where diverter valve was on my 09 so i could install my bov 💕
Best video I could find online. It’s almost impossible to see. I had a revision “C” and replace with a “J”. Thanks
Thanks Guy's... Just did a new valve plus the GFB DV+ Kit on our MK6 GTI. Connector Plug was a bit stubborn but we got it. Very pleased with our efforts.
This video was very well presented and better than any repair manual!
I changed this valve this year.
It was leaking small amount of oil
It leaked for 4 years. Small amounts...
Finally I was able to change it.
Much clean back there now..
Yes, that's why we just did my sons car. Discovered it was an older revision and kept finding the connector with oil on it....
Daniel Medrano I just noticed on my MK5 k04 oil leak from this diverter valve spacer is this normal ?
@@raptor9926 Is there a gasket on the spacer?
Holy smokes. I just did this. I had a really hard time getting to the lower left bolt. Things are so much easier when you have a lift.
Ed Sheeran working on VW’s now?
Excellent demonstration
Thanks! This along with humble mechanics vid on this part I feel super confident about doing this myself!
Long time subscriber, first time watching this video. Great opening line 😂
Just watched the vid. Excellent camera placement. Great vid except at the end just before you appear to say finished you will notice that the 5 mm allen tool is still on diverter fastener!
Really adds too the whole experience lol
Great and easy to follow video
You should post one of these videos for 2020 VW Passat se installing the DV+. not too much info out there because the job requires access from underneath.
Have you got a video showing all the vacuum hoses on an FSI too please?
Excellent show, thanks a lot. I might consider doing it myself, that is, my friend lets me use his crane...
How do you unclip the connector? I see how it clips on the new one but can't get the clip off the old one.
I have the same problem. How did you end up getting it off? I'm afraid to break it. @MPDano
Phil Trujillo Same problem here
@@kkelv I know it's been 3 years but you push back on the little tab while pulling the connector in the other direction. Try with your hand before using a screwdriver, more prone to breaking. Good luck lol
after replacing this sensor the check engine light is supposed to turn off on its own or something else needs to be done?
informative article. thanks
Thanks for the vid. I have a 2012 Jetta GLI/tsi 2.0t . I purchased the valve part number 06h145710d. Is this the right part? The harness seems different.
Good job
So it looks like there is some sort of plate over where the location is shown in this video.
There is however an identical looking part up by the right hand side of the front grill that is attached a large air hose, attached to the plastic turbo Inlet pipe, any ideas what's happening here?
How difficult is it to do this on the driveway?
are you doing a performance build on this? would you consider using a Go fast bits DV+ on this? why or why not?
Hey I have a 2014 1.8 T, trying to replace the valve from underneath with ramps. It’s so difficult to reach. Any recommendations?
Thanks!!! A million
guys , where is location for DV valve on 1.8tsi ? EA888 gen 2? same like 2.0 tsi or ?
Would this fix a low compression problem on cylinder 3 on the 2.0T FSI engine? If not, what are the obvious suspects? Valve issues, etc? What's the typical cost to have a valve job done on this engine? Thanks, Mark
450 at a dealer. That's why I'm here lol
Can you access this through the fender?
Can I use this on my Alltrack 1.8 Tsi? Will it fit?
Thank you!
is it same for tdi? I can't seem to find it
On a 2008 audi TT 2.0 tfsi error code p2261 is this the correct part to start with first?
Its can oil leak from this?
Is a diverter valve also known as a turbocharger recirculation valve?
yes
Is this the same for a 2012 Audi A6 2.0t
where the crankshaft sensor passat 2.0 tsi 2009 is located behind mutilple or between the transmission and motor
Is it the same location on a 2016 Tiguan SEL?
It's up top on newer cars, it's one of the first things he said.
Good luck using that socket combo on the actual car
Please tell me I can put a diverter valve on my TDI???
how do you do the DV valve on a gen 3 1.8t passat say the 2014 flavor?
Wondering if this is the same part we need?
We have a 2014 VW Jetta, Trouble code P0045 Turbocharger / Supercharger Boost control solenoid A Circuit/ Open
Your time is greatly appreciated.
can i do the same thing on my mk6 gli
What about a 2017 where is it located Jetta tsi 1.8t
i can’t find the tucking thing for the life of me
I need a Valve specer for this gen3 , when
What would be reason to upgrade a DV in a MkV?
geekphreak the old valve fails
The old valves with a bellows type diverter rip and leak boost to atmosphere, they changed the design to a piston which is more robust than a rubber bellows.
Błąd p2261 również od dv?
Would the location be the same on a 1.8L EA888 Gen 3?
B7 Passat Dude lol I just almost dropped half my turbo charger just to install mine on a 2014 vw gli gen 3 2.0T
Joe DeSimone I’m thinking of paying for the install but idk if it’s really worth it putting down 400 just to get it on. );
Joe DeSimone I’ve a 2016 GLI. Is the install procedure and location the same like in this video ?
" A Ridiculous amount of extensions"
:D
post 3.6 vr6 mods please
I've been trying to change it on my car, but I don't have the ability to lift the car up. Let me tell you how much of a pain in the ass it is to even lift it up.
Drive up ramps at Harbor Freight Tools. Probably $40 max. Just dont overshoot the ramp and youll be about a foot off the ground.
You left your 5mm on the diverter vale.
We like it there!
@@Deutscheautoparts ready for next time! :D
Not enough extensions.
U forgot ur tool in their
ok