How to Operate a Servo in Speed Control

anaheimautomation.com This instructional video will guide you through the process of configuring the EDB Servo drive to run in Speed Control mode. This video is specific to the Anaheim Automation EDB Servo Driver series only. Visit anaheimautomation.com for details on a broad line of industrial grade Servo Motors and Drives!

[@FERNANDOPENAS]

Hi,
I have 3 servo drives, the motors are DC synchronous with the drives integrated in the housing.
I read all the documentation that I could find about this motors, and I still am trying to figure out how i will connect this motors as that it receives the signals from a G-code Software.
There is 2 input pins for data and 4 for power and ground. .. 24 volts for the drive, 300 volt dc for the motors and 5 volt for something else.. the data pins are 2 and are named high Can and Low Can. I figured that the signal transposting the data are can protocol, so i am going after some information of this technology and as I could understand so far, Can bus are only the protocol of data transfer from the controling unity to the servos ..
What I am trying to figure, without resources to test, is ... what kind of signals should be sent from the controling board via can bus to the drives, and if there is any device that will be needed to translate this signals into can bus before it reachs the drive..
Sorry about my question, it may sound dumb to someone whos expertise is beyiond mine, but i need this information to progress in my project and in my knowledge of this systems.. .
Anyone can help? I reformulate the question if it is not well presented..
Thank you

[@EugenioCiullo_V-Blog]

this drive can receive pwm + dir signal? i want to use it with my arduino

[@icesps6809]

can you tell me how to connect this driver in position control mode and which parameters must be changed please?

[@Mtixgame]

thanks
very nice

[@abhishekrathore5614]

i am looking for technician for maxsine servo drives machine stopped and jog motor not moving properly

[@mohankumarn8675]

I want, how to set sew drive parameter

[@rafaalfarizqi631]

Nice

[@arsalanarsalan1572]

Sarji meri Sarvo mortar ka Lok htana he tariff ka btado net pe

[@mehdijamshidi4931]

Hi dear
According to the attached image, an alarm has been generated in the drive display, how to fix the problem
(Alarm display A.04 Overload : The servomotor is operating continuously under a torque largely exceeding ratings)
Where is the problem and how to solve this problem?
Thank you for your guidanc
Best regard

[@Anaheimautomationinc]

Hello,
Thank you for your question. Our engineers will be happy to assist you. Please contact them directly at [phone] or [e-mail] and they will respond to your request as soon as possible.
Have a great day!

[@liliwarli5550]

Wiring position control mode servo drive AASD ???

[@SKCCNCROUTERBATAM]

ruclips.net/video/EUzPhriRn1s/видео.html

[@RuiSjm]

Hi, what is driver conts from 1 to 5 and not start up? Only see 5 number on lcd, thanks

[@Anaheimautomationinc]

Good afternoon. Thank you for contacting us with your question. Our engineers can certainly assist you with this problem. To contact them directly, please call our offices at [phone] or email your request to [e-mail] and you will receive a response as soon as possible.

[@AbhishekSharma-ty2hp]

Sd310का विडियो

[@OPArya-gg4ks]

Bilkul bakvash sound bilkul bhi nahi hai.

[@omar7amdi]

Talkless. workless.

[@heldulfs]

u mean useless