Jeep windshield bolt extraction/ removal.
HTML-код
- Опубликовано: 12 сен 2024
- This is a How to video to remove Jeep CJ, YJ, TJ, JK, JKU, JL windshield frame bolts after the torque strips out the bolt head.
This is a simple how to video on how to remove the windshield bolts with a drill bit and easy outs/ extraction tools. This does not always work and sometimes you still have to drill out and tap the 5/16" bolt or bolts.
The link below are link or links to tools used in this video.
www.amazon.com...
never really thought of the leverage thing, next time i use an easy out imma grab a tap handle...same principle as taps and ive used em a thousand times can't believe i didnt think of it till i watched you, thanks man preciate it.
If you have room to use then they are great. There are a lot of locations there is no room to use one.
Excellent advice in this video, this is the best method thanks!
Thank you Chad
Awesome sauce! Thanks. I just stripped one really good and starting to on the other side. Someone else was advising to use a propane tank but I’m concerned about the paint. This I’m going to try right now. I was trying my extractor bits like yours but the technique was slightly different. 👍
Good tips. I had some that were badly ate up. They ruined my lisle made in USA torx bit. I went to auto zone and it was made in Taiwan. It survived the worst ones and did the job with no damage to the tool. Surprised me. I'm always USA.
Thanks for the tips and tricks itll help a ton im sure. You seem like a wise man with experience.
I’ve been rebuilding vehicles since the late 80s.
Good video, for me the welded nuts on the back side broke😂
thanks chad great video..
Thank you sir you saved my day
Your welcome
Thank you!
I’m going crazy. I’ve tried this too and the easy out is stripping thru too. I think I’m going to have to use my drummel and cut a line for a flat head. 😵💫🤬
Drilling the head off. Then make sure you verify the drill was centered in the bolt. Then drill a hole in the center and see if that will relive the pressure enough to easy out the bolt. I’ve had some that were so bad I’d have to make a new plate.
Just weld a nut to the head of the bolt.
Interested in how your floor is set up, I’ve got a rusty 92 YJ that I’m looking at different floor options
@@Nick87899 i built a new one. Chassis, floors and roll cage. Thankfully you can buy replacement pannels for the tub.
Don't break da knees...oye...