Not worth watching: don't waste your time. 17:15 to 18:45 were critical minutes, but the robot was out of camera view. Finally, when having difficulty removing the sensors, the video ends.
Your sensors are faulty, unfortunately you can’t disable them by just removing them, it’s a risk fixing it because they sensors could either be broken or your motherboard is, you risk whatever the cost and time it takes. I’m personally trying to find some cliff sensors to attempt to fix a M7 Pro
Not worth watching: don't waste your time. 17:15 to 18:45 were critical minutes, but the robot was out of camera view. Finally, when having difficulty removing the sensors, the video ends.
You're a legend
Any idea if completely removing the sensors would work? I can't seem to make tape method work
Your sensors are faulty, unfortunately you can’t disable them by just removing them, it’s a risk fixing it because they sensors could either be broken or your motherboard is, you risk whatever the cost and time it takes. I’m personally trying to find some cliff sensors to attempt to fix a M7 Pro
Do you know how to take off the clip to release the wheel?
, I wish that Roborock S6Maxv have same type sensors so they get out same (difficult way)...
Do you have filmed the second part of it?
Ok thanks, but the only problem is had was exactly the part you don’t show!
Man why did you need to replace cliff sensor? Did you get a error 2, clean and tap the bump slightly?
you destroyed that poor thing 😅
Ok. You dismantle it completely and then what??
why TF need to show everything in 23min instead of summing up in 2 min?
Very hard i think
this is so complias process