Air Bending with Offset Tools | Bending | Technically Speaking

[@niazpanhwar]

I have situation Offset height is equal to sheet thickness which are 3 mm and 2.5mm and angle to be 90.

[@elijahbriar3734]

A trick : watch movies at kaldroStream. I've been using it for watching a lot of movies during the lockdown.

[@maxmario9196]

@Elijah Briar definitely, have been using kaldroStream for since december myself :)

[@waynemiller484]

@Elijah Briar yea, I've been watching on Kaldrostream for years myself =)

[@BradleyWilloughby]

That particular press brake features an NC9-EX(II?) controller. When you multiply the offset by 1.414”, does that mean you can actually program that tool in angle mode, or are you all using depth mode?

[@WilsonToolInternational]

Hi Bradley
Depth mode works much better for this type of bending on the NC9EX controller. Angle mode would likely work, but it would require a lot of angle correction to achieve the desired results.
If you have more specific questions please feel free to email us at [e-mail]

[@blassaviles2512]

@@WilsonToolInternational yes Depth mode is the best way to make this process.

[@jaychino1621]

Are there U channels available for this press?

[@ronnield]

I am new at press brake where can I learn more

[@WilsonToolInternational]

Hi Ronnie ... you can learn more about Press Brake Tooling at www.wilsontool.com/bending. If you have a specific questions email us at [e-mail] and our Tooling Technicians will help you out.

[@chamferededge7117]

How do you program this into control? DELEM?

[@WilsonToolInternational]

Thank you for your question.
Due to the uniqueness of each application it is best to email our Tooling Technicians at [e-mail]

[@niazpanhwar]

I have situation Offset height is equal to sheet thickness which are 3 mm and 2.5mm and angle to be 90.

[@WilsonToolInternational]

Thank you for your question. Due to the uniqueness of each application it is best to email our Tooling Technicians at [e-mail]