joetca I hope you used a darker grout color or slightly darker color when re grouting. This is our biggest mistake. We use grout too light on color. Everyone has been doing what the tradesmen think is the right color and haven't been listening to the women of the house. The person who ends up doing 99% of the cleaning. It is only in retirement that my husband has been allocated cleaning the floors and grout. He also laid the tiles while I was away as a surprise, so color selection was all his. Guest who is going to be removing the grout and re doing it, early new year.
The music made this job look and sound so sexy! I had to keep in mind I have a long road ahead with repairs 🤣. Thank you for the helpful and pleasant video!
There is a $25 toool called Grouter Outer that removes grout from floor tile much faster than this, and it does not eat up expensive blades every few tiles. And all you need is a drill.
At the end of the video it doesn't look like the sub floor is at all clean enough for the new tile. Pretty sure All of the thinset has to be removed. This doesn't even get you close.
GW Richards yes you absolutely right the cement has to be removed. Otherwise new tiles can't be reinstalled. Maybe you did not see job fully completed ...but we can ensure you everything was done right.
Is it very costly to remove tile? We asked our builder to close without tile, but they wouldn`t allow it. I would love to change them but concerned about cost
MS S allow between 1 - 2 days to remove tiles depending on size of floor..... smaller floors allow 1/2 day - base day rate between 150 - 200 for removal.
Maybe in Residential you'd get away with that but on a Commercial site your grinder would have to have the guard on it. Unless you want to get that OSHA $10k fine
Worry about Osha fine you ??? Where in your house by removing one tile ??? So funny comments so many other regulations that many guys don’t obey and here you are worried about oscillating tool plus vacuum on it safety glasses ear protection 10 k ? Are you serious? Get a real job pale 😂😂😂plus gloves 😂😂😂😂
the tile hasnt been set properly... look at the lines in adhesive, there shouldnt be any at all... he pulled it properly, but didnt set the tile so it spreads...
The person recording needs to hold the camera still and center the tool within the frame. Not waving it around. And... Don't put up instructions on screen then wave it around... You can't read it.
Thanks for the sultry music, I am now not intimidated by my tile regrouting.
joetca I hope you used a darker grout color or slightly darker color when re grouting. This is our biggest mistake. We use grout too light on color. Everyone has been doing what the tradesmen think is the right color and haven't been listening to the women of the house. The person who ends up doing 99% of the cleaning. It is only in retirement that my husband has been allocated cleaning the floors and grout. He also laid the tiles while I was away as a surprise, so color selection was all his. Guest who is going to be removing the grout and re doing it, early new year.
The music made this job look and sound so sexy! I had to keep in mind I have a long road ahead with repairs 🤣. Thank you for the helpful and pleasant video!
Couldn't stop groovin' to the music.
Your camera needs a taxi lol
Good video and neat work. Too many jealous people in the comments
Is there no audio, just jazzy music?
How about the water proofing?
Brilliantly done 👍🏼 were the tiles porcelain?
There is a $25 toool called Grouter Outer that removes grout from floor tile much faster than this, and it does not eat up expensive blades every few tiles. And all you need is a drill.
I checked, site closed.
Can you share where is it ?
what is the second tool used that is used to remove the tile?
the thing that acts like a chisel is a "5 in one tool" if that's what you're asking :)
the music is better than listening to the oscillating tool compete with the shop vac
At the end of the video it doesn't look like the sub floor is at all clean enough for the new tile. Pretty sure All of the thinset has to be removed. This doesn't even get you close.
GW Richards yes you absolutely right the cement has to be removed. Otherwise new tiles can't be reinstalled.
Maybe you did not see job fully completed ...but we can ensure you everything was done right.
It’s fine. It don’t all have to be removed and is almost impossible and totally a waste of time
That tile and probably the whole floor was not laid properly in the first place.Floor tiles must be back buttered.
Yes you're right installation was done very bad...
FELIX CECCONI back butter helps, but pounding tile in with mallet is only sure way to get it set in good.
No they don’t
Is it very costly to remove tile? We asked our builder to close without tile, but they wouldn`t allow it. I would love to change them but concerned about cost
MS S allow between 1 - 2 days to remove tiles depending on size of floor..... smaller floors allow 1/2 day - base day rate between 150 - 200 for removal.
Is it an angle grinder or a multi tool
It was a multi tool with a 360 degree wheel that you can rotate as it wears down. I just bought one today and it's a diamond blade.
Video: Excellent.. Thanks for posting! Video effects: Less is more. Stop it. :)
subscribe to see New ideas for installation ruclips.net/video/I1gNpHsmANY/видео.html
Must be a variable speed grinder.
Maybe in Residential you'd get away with that but on a Commercial site your grinder would have to have the guard on it. Unless you want to get that OSHA $10k fine
Jason Paden that isn't a rotary. It's an oscillating.
I didn't say it was either. Plus that doesn't matter in any way. The guard is off. That's an Osha $10k fine
There is no spinning shaft therefore no need for a guard. They aren't sold with guards and they aren't required by OSHA.
Worry about Osha fine you ??? Where in your house by removing one tile ??? So funny comments so many other regulations that many guys don’t obey and here you are worried about oscillating tool plus vacuum on it safety glasses ear protection 10 k ? Are you serious? Get a real job pale 😂😂😂plus gloves 😂😂😂😂
Is that just a 4.5 inch grinder
its an oscillating tool not a rotary
We want to remove the tile as whole
get yourself a carbide Rasp for your multi tool instead to remove thinset
the tile hasnt been set properly... look at the lines in adhesive, there shouldnt be any at all... he pulled it properly, but didnt set the tile so it spreads...
If they were backbuttered when installed, it wouldn't be that easy!
Exactly
I take it that is a special blade that is smooth on the sides...
Probably a carbide blade on a variable speed bringer. It’s not shaped like a multi tool grout remover.
The person recording needs to hold the camera still and center the tool within the frame. Not waving it around. And... Don't put up instructions on screen then wave it around... You can't read it.
sir we need this
Excellent demo..
I liked this video and no need for words. Camera was fine you jerks.
The wavy camera work makes this hard to watch.
Nice3
Russell allen put in
Çok acemice 20 sene önce yapardık şimdi kalekim var zorlama kendini yaz gogila kalekim bak neler var kendine iyi bak hoscakal