Echo Chainsaw CS-352: Installing Carb Kit and Get Running Like New
HTML-код
- Опубликовано: 18 апр 2022
- Thank you for watching! If you enjoyed the video, or found it useful, feel free to like the video and subscribe for more content! I recently launched my merchandise shop! The quality of the merchandise is great and the designs look amazing! Feel free to check them out! All support is greatly appreciated :)
L&M Store Link: landmrepair.myshopify.com/
Awesome tutorial - thank you!
you're welcome
Easier seen than done. I just smash my cs 352 against the comcrete. 1st putting the fuel lines then lastly the throttle level bar I couldnt figure how to put it. Game over.
Thanks anyway for showing us.
great video, thanks for that. I think my primer bulb is on its way out on my 352. Would love to see you do an oiler replace.
on what kind of saw
Echo 352. I have 16 bar on it
Second gasket and diaphragm backwards? When reviewing your video it appears you might have installed the second gasket and diaphragm "flipped" from the way they were taken off. The button, not the wheel, is visible when you remove the plate to take off the second gasket/diaphragm. When you put it back on you had it flipped so that the wheel was showing.
What is the part number of CS-352 carb kit you used in the video ? thanks.
on the side of the carb there are 3 letters or numbers thats how you find a kit
Walbro D10-WTA I believe
My cs-352 turns on but then dies about 5-10sce any advice
You did it wrong on the metering side. On the metering side first the gasket, then the diaphrame but with the right side down.
I have this saw. How do I adjust the bar oil output? Can't find a screw.
there should be a screw on the bottom of the saw
@@lmsmallenginerepair4471 there isn't. It is self oiling only. What a dumb idea. A way to save a couple bucks