Changing zone types on a Bosch Solution 2000 and 3000 system using the LCD Icon keypad.

This video will show you how to change the zone types on a Bosch Solution 2000 and 3000 system using the LCD Icon keypad.
Keep following us, more videos coming soon!
Leave your comment and like us!
Follow us on:
Facebook - / cheapalarmparts
Instagram - / cheapalarmparts
And visit our website www.cheapalarm...
“All videos, images, content and material produced by Cheap Alarm Parts are copyright 2021 and may not be used in any way or reproduced or edited without express permission from Cheap Alarm Parts.
Linking and sharing this video directly without any alteration is acceptable.”

[@Dentinvent]

I think I'm in love with Liora. What a beautiful voice she has ! Great tutorial and thanks.

[@paulkaciuba7252]

Brilliant video. Absolutely brilliant. Perfectly explained, perfectly displayed information, perfect demonstration. Not too short, and not unecessarily long. Thanks.

[@CheapAlarmParts]

Thanks!

[@ba4820]

Great Video very helpful

[@CheapAlarmParts]

Thanks!

[@johnnyvong2632]

thankyou so much your video are very helpful !

[@2loco]

Have you ever been employed by Vodafone, because I just spent an hour on the phone with them and damn the bot sounds exactly like you. 😅

[@CheapAlarmParts]

Thanks for holding ... your call is important to us ... Thank you for using Vodafone.

[@ba4820]

@@CheapAlarmParts Funny

[@georgekounelis2723]

Hi great videos.Im having problems with a bosch 2000.The faut icon is the only thing illuminated on the key pad.It wont arm. All it does is beep when I press any buttons.Battery & transformer are in good order.

[@CheapAlarmParts]

Usually a cable fault if it was working previously. I suggest powering the unit down and powering it back up and see what happens. Is this the only keypad on the system?

[@georgekounelis2723]

Thank you for your reply.I found the key bad was faulty,all good now after I replaced it.

[@GersonIda]

Hi, I have a Bosch 3000 system and while testing it, when the sensor detects movement and it triggers the alarm, once I disarm the system, the display still showing that zone is in alarm condition (zone number flashing fast). How do I reset so the zone goes back to “not in alarm condition”? Thanks. Gerson

[@CheapAlarmParts]

Arming and then disarming the system will clear the alarm memory.

[@Tinman64]

Good video but still have a question. I have programmed the zone type but When I wire the smoke detector does it need a resistor in the circuit?

[@CheapAlarmParts]

Yes, all zones need a resistor, including smoke detectors.

[@royaliptv]

Great video, thank you Saul and liora, what is the time for each zone type? and ist adjustable or fixed?

[@CheapAlarmParts]

Delay times are adjustable from 0-255 seconds.