So far with my experience, I like stabilizers that it comes with but they definitely need some lubing. I would also give it a tape mod and maybe remove some gaskets if you want it more bouncy :)
So I have the 5075b plus cinamon roll edition and it doesn’t have screws on at all except the pcb and in my experience you must use pry tool made specifically for prying like the ones you find online I tried using like debit cards and and a flat head screwdriver and basically scratched the mf like hell thankfully doesn’t show up too much when you finally reassemble the board but I sure as fuck came close to breaking the side leds twice right now the side leds are scuffed up pretty bad but again doesn’t show up when you put the cases back on maybe you’ll get the same results when you use the pry tools as well but still be very careful with the side LEDs and make sure where the points where the keyboard snaps back on are
Thank you for this video. I'll try to make it as silent as I can with silent switches and maybe something for the bottom of the case.
I like your idea, I've also started getting tired of noisy keyboards
akko 5075s or gmk87? which one has the best quality
They're both solid, but i personally like the akko more. It's just a choice on if you want wireless or wired
Planning to buy this one, what mods u can recommend and is there anything stock that i should change or removed then continue to modding it?
So far with my experience, I like stabilizers that it comes with but they definitely need some lubing. I would also give it a tape mod and maybe remove some gaskets if you want it more bouncy :)
Have softwre this keyboard?
This keyboard uses "VIA" as the software, its a website app
@@Entaxo ty
How did you pry open the case?
Since it didn't have the switches and keycaps I just pulled the top case away and up from the keyboard, but I've seen others use pry tools as well
@@Entaxo is it easier to remove without the switches? didn't proceed today, because i find it a bit stiff
@kennosamulde1735 the keyboard is pretty difficult to take apart in general, but you can definitely open it with the switches and keycaps on
So I have the 5075b plus cinamon roll edition and it doesn’t have screws on at all except the pcb and in my experience you must use pry tool made specifically for prying like the ones you find online I tried using like debit cards and and a flat head screwdriver and basically scratched the mf like hell thankfully doesn’t show up too much when you finally reassemble the board but I sure as fuck came close to breaking the side leds twice right now the side leds are scuffed up pretty bad but again doesn’t show up when you put the cases back on maybe you’ll get the same results when you use the pry tools as well but still be very careful with the side LEDs and make sure where the points where the keyboard snaps back on are
is there not enough room between the PCB and bottom case for EVA or Polyfill mod?
there definitely is, but the gasket performance will most likely be reduced. :)