How to connect and configure danfoss Vfd tru Siemens Plc using a profibus cable..?

Hi..in this video..i will show how to communicate and configure a danfoss vfd tru Siemens Plc S7 300..
thanks for watching

[@hichamos_1hichamos_13]

Thx so much really amazing continue sir

[@palanipps]

Hi one doubt plz..in Modbus communication we are using address registers..in profibus what can use like address register?

[@manaylizfamilylife]

Sending my support..nagpalit po pala kayo na yt name..

[@electricalplcbasictutorial7531]

Opo manay liz.. Salamat sa pag bisita.

[@bhaveshpurani8042]

very nice man

[@arnolyoel9639]

Nice video, but in the VDF u have to change something in the case that the VDF is new?

[@electricalplcbasictutorial7531]

yes sir

[@sinanartemis6176]

hi how about adressing can you show us how can we do that adressing at plc side

[@electricalplcbasictutorial7531]

as of now..im on vacation..soi dont have a Laptop to give you a sample video.but ..if you look in my previous videos..i know i have a.sample how to make addres in plc.

[@sinanartemis6176]

@@electricalplcbasictutorial7531 thanks but for example i watched many plc videos on profibus but ı didnt understand i mean İ learn how to select vfd how to select ppo and ı saw some people use some adressing as w#16#047f or other where is cames i didnt understand that

[@McAndreJan]

Sir pwede po ba gimamit ng personal laptop para ma program ? Or need Taga Yung laptop ng seimens?

[@electricalplcbasictutorial7531]

pde nman basta mataas specs ng laptop mo sir

[@achiever2569]

Please make a video from tia portal and profibus in English

[@electricalplcbasictutorial7531]

ok sir

[@hichamos_1hichamos_13]

I need understand analog programme in s7300 by ASinterface

[@mustafaha5484]

Hi sir can you teaching as plc s7-200 microwin how connected vfd

[@electricalplcbasictutorial7531]

S-200 actually i dont have here in our work. So i can't teach.. But its just same as s7-300

[@binhtthnguyen2483]

When I connect the motor, I get the error W34 ? I look forward to your guidance!

[@electricalplcbasictutorial7531]

there is a.manual for every error sir.hope you can read it ..

[@electricalplcbasictutorial7531]

warning W34 is for profibus fault..if there is no profibus needed..no issue for this..you can run it.

[@vok7584]

Pls what does the Danfoss status message "Auto Remote Inhibit" mean?

[@learning9503]

hahahahaha