EASY And CHEAP DIY Rust Repair on Your Car (Without Using Any Special Tools)

Поделиться
HTML-код
  • Опубликовано: 14 окт 2024
  • In this video we will show you rust removal and repair. Repairing rust on your car is something that should be done quickly to prevent it from spreading. It can be easily done without welding or any special tools; by using strong but inexpensive body filler. You will even see us paint the car ourselves. Rust repair is common at the wheel wells and rocker panels of cars and in this video we show the proper and most thorough way to remove and repair rust.
    Products:
    Glass Filler: amzn.to/39b4We0
    Gold Filler: amzn.to/2ToR6h8
    Adhesive Remover: amzn.to/2Vnez58
    Sandpaper: amzn.to/3955oKD
    Spot Putty (not in video but helps cover up small holes): amzn.to/397GdXY
    Polish (not in video but eliminates scratches, swirl marks and more): amzn.to/32uEIQQ
    Dust Mask: amzn.to/2IcXp2t
    Sanding Block: amzn.to/2I0VJsM
    Paint:
    Rust Reformer: amzn.to/39g8L1z
    Filler Primer: amzn.to/2T30ZSG
    Color Matching Paint (make sure it matches your vehicle): amzn.to/32uBg8S
    *If this video was helpful, remember to give it a "Thumbs Up" and consider Subscribing. Really appreciate it!*
    Disclaimer:
    Due to factors beyond the control of Auto Ignite, we cannot guarantee against improper use or unauthorized modifications of this information. Auto Ignite assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Auto Ignite recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Auto Ignite, no information contained in this video will create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Auto Ignite.

Комментарии • 52

  • @raach77
    @raach77 2 года назад +8

    This is a much better and explicit video than 1 and 5 million views videos I've seen

  • @maxlandy7642
    @maxlandy7642 2 года назад +23

    Looks a lot better than it did but the damaged area is so obvious to the eye. Clear difference in height. Needed more prep to ensure is was feathered into original paint

    • @immanueldelcastillo6041
      @immanueldelcastillo6041 2 года назад +1

      lol. This is how exactly how it looked like when I brought my car to a dealership for repair. Might as well do it on your own 😜

  • @mickeymcmoore5412
    @mickeymcmoore5412 2 года назад +43

    Good video - the totally unneccesary music was distracting though.

    • @catrinacatalin
      @catrinacatalin 2 года назад

      You have a button on your phone to lower your volume if you dont like the music.I hate how most of people like to bla bla all the time when the solution is so simple

    • @mickeymcmoore5412
      @mickeymcmoore5412 2 года назад +13

      @@catrinacatalin I actually do know where the volume knob on my speakers is. Muting the music mutes the very helpful and informative instructions.

    • @Dark_Souls8907
      @Dark_Souls8907 3 месяца назад

      Lmao, that is probably the best reply for this situation ​@@mickeymcmoore5412

  • @duncanmathers76
    @duncanmathers76 Год назад +10

    Good tips here, thanks. But the music is too high in the mix here and we can barely hear you at times!

  • @no-rj2ez
    @no-rj2ez 2 года назад +3

    Do u put rust converter on the outside or just the back?

  • @bigoz7
    @bigoz7 Год назад

    Cool vid very informative and thanks for sharing!

  • @yeehaw398
    @yeehaw398 7 месяцев назад +1

    3 years now. How did it last?

  • @dailydad6335
    @dailydad6335 Год назад +1

    How long this will take to do, i have rust but not as bad as that do i need a filler

    • @dawidkenway5649
      @dawidkenway5649 Год назад +2

      most importantly you should get rid off all the rust to the bare metal, some rust prevention spray and i guess you could use a bit of body filler depending on how much you sanded and then just put fill in primer and paint

  • @samfromprague2688
    @samfromprague2688 Год назад

    Perfect 👍👍

  • @attiliobarcados8178
    @attiliobarcados8178 2 года назад +8

    your music in the bakground is too loud

    • @catrinacatalin
      @catrinacatalin 2 года назад

      Your phone volume was loud and you have a button wich can lower the volume or mute🤮

    • @erosennin4444
      @erosennin4444 Месяц назад

      ​@@catrinacatalin except if we do, we can't hear him talk. Don't be ignorant toward others

  • @Clos-wx1mv
    @Clos-wx1mv Год назад +1

    When you primed it 3 coats ...did you also sand it down with 600grit too? 3 times

  • @martymcfly3986
    @martymcfly3986 2 года назад +33

    3 months later doing it all over again

    • @dailydad6335
      @dailydad6335 Год назад

      How?

    • @zbigniewkaminski6068
      @zbigniewkaminski6068 Год назад +10

      ​​@@dailydad6335 He didn't remove rust completely. Yes, he used rust reformer, BUT this doesn't guarantee full protection against rust. To remove rust correctly you have to remove rust completely

    • @roscoross7797
      @roscoross7797 Год назад +4

      ​@@dailydad6335not if its sold.

    • @nickkerr4893
      @nickkerr4893 Год назад

      And i think the fiberglass filler is also Not needed there is no hole or something to fill, if He just sanded it more to the metal then put rust Reformer on it and the normal filler is enough then ground spray and color spray

  • @craigc1463
    @craigc1463 11 месяцев назад

    Why Bondo & Body Filler?

    • @kasperkarlsen2316
      @kasperkarlsen2316 7 месяцев назад

      Since you are removing material (rust and metal) from the damaged area. Bondo and filler will fill the area back up so it matches the body lines.

    • @youcanttouhme8955
      @youcanttouhme8955 7 месяцев назад

      İts not like he has removed alot of metal , it's kinda useless in his situation​@@kasperkarlsen2316

  • @mortal106
    @mortal106 Год назад

    Fiber glass cracks though

  • @girtsreders6987
    @girtsreders6987 3 года назад +14

    I can see with my eye that thats not a good fix

  • @ZloB1N
    @ZloB1N Год назад

    nice video. without music would've been ideal

  • @fojnica2226
    @fojnica2226 3 года назад +4

    WHY CLEAN AREA FIRST THEN MAKE DIRTY WITH SANDING..NO PIONT

    • @jasonchristopher2977
      @jasonchristopher2977 2 года назад

      Just wash so there's no mud, oil, grease with a good degreaser. Alcohol, thinner, acetone etc. You MUST remove, convert, kill all rust, inside, outside etc. Ospho, converter whatever. A small hand held spot blaster on 75 psi would've been nice to get it gone but not hurt metal or get messy.
      You don't want any of that sanded into, onto the metal. It will stay and make finish crap. All this kind of work is the prep. You can paint with a used brush and roof tar but if prep is crap it won't last or look good. Anyone can paint, the magic is the prep. Do spend most time on cleaning, sanding, and getting ready for primer. After that your good. I've seen a lot of nice paint look great from 20 foot. Get up to it and you see sand scratches, dents, putty etc. That's a 50 mph automobile. looks great moving at 50 MPH. Looks like shit parked. Like the hot chick you see from behind at walmart then turns around with no teeth and a busted face. Butter face. Everything's looks good But her face. She looked great from down the aisle but get close and 360 view. Uggh

    • @johnny207
      @johnny207 Год назад

      Your comment had no point! Learn to spell first ffs.

  • @jordansuby10
    @jordansuby10 2 года назад

    Couldn't even watch it with the loud ass music. Cant hear any of the info at points smh

  • @gcooper642
    @gcooper642 2 года назад +2

    There are 4 lights!

  • @sonnyhayes123
    @sonnyhayes123 Год назад

    i dont think you need the alchohol mate

  • @mixedboi
    @mixedboi Год назад

    The rust is on the other side though.

  • @gungadin164
    @gungadin164 2 года назад

    The camera work is nauseous

  • @wandajames6234
    @wandajames6234 Год назад

    yes ditch the music, can barely here you

  • @cornerro
    @cornerro Год назад

    what a good tutorial it'd be without that f@@@g annoying music in background!

  • @stan-ut5gj
    @stan-ut5gj 11 дней назад

    Lose the music my friend...annoying so I left!

  • @RadioNul
    @RadioNul Год назад

    AAHHHHH THE MUSIC WHY

  • @TAKASHI2010SAM
    @TAKASHI2010SAM 4 месяца назад

    why are u using 2 fillers ?

  • @mattbriggs2049
    @mattbriggs2049 Месяц назад

    Man turn that damn music off

  • @painterman235
    @painterman235 8 месяцев назад

    Awful video ...

    • @keemoify
      @keemoify 7 месяцев назад

      Calm down

    • @6ixxFlixx
      @6ixxFlixx 11 дней назад

      @@keemoifycalm down

  • @BenHooker
    @BenHooker 2 года назад +2

    You stole @ChrisFix video step my step exactly. Come on man. Be more original