3155D Genie or similar belt drive garage door opener wiring

Поделиться
HTML-код
  • Опубликовано: 30 окт 2024

Комментарии • 14

  • @MultiTony41
    @MultiTony41 Месяц назад

    This is very helpful thanks you

  • @nram1
    @nram1 Год назад +1

    Easy to follow. Wish I could see more of the connecting wires to the opener.

    • @dareeboi
      @dareeboi 9 месяцев назад

      white wire always goes first black right after then yellow then green

  • @lamnag01
    @lamnag01 Год назад

    Thanks for the curly wurly tip @ 05:48. Handy little tip.

  • @mikestavros1574
    @mikestavros1574 Год назад +2

    Thank you. Very helpful information - especially the wiring for the safety sensor to the powerhead. Install instructions lacked the info on how to connect.

  • @gonzo3618
    @gonzo3618 Год назад +2

    Very Well presented .Thank you.

  • @adeelkhan2335
    @adeelkhan2335 Год назад

    Thank you

  • @cbirckhe
    @cbirckhe 13 дней назад

    Thanks for posting but what the heck is the black wire sticking out. There is no mention of it in the instructions. Nor do you mention it as well.

    • @johng2913
      @johng2913  11 дней назад

      On the opener motor? Receiver antenna.

  • @AlvaroEspinel
    @AlvaroEspinel Год назад +1

    The most important part, the connection of cables to the panel is very difficult to follow. 😢

  • @nram1
    @nram1 Год назад

    The instructions said to put the wires through the wire control channel. There is none with this model which is unfortunate because the wires are just there.

  • @michaelsmith-gc8wt
    @michaelsmith-gc8wt Год назад

    if it doen't matter which wire goes where in the consol then it shouldn't care in the powerhead

  • @LilDongers
    @LilDongers Год назад

    Song?

  • @larry1708
    @larry1708 7 месяцев назад +1

    Terrible video. What we need to see is wHICH wires to connect to WHICH Terminals more than the common sense connecting