66Mustang; How to replace driveshaft universal joints

How to replace driveshaft u-joint using two different methods; using bench vice and using BFH hammer, replacement on our 1966 Ford Mustang project!
PLEASE LIKE, COMMENT & SUBSCRIBE!!
THANKS FOR WATCHING VintageSpeed Garage! We appreciate your support!
WEBSITE - www.vintagespee...
INSTAGRAM - / vintagespeed1956

[@mwc9650]

Just what I was looking for. Thanks so much.

[@Titan-uy1qy]

Thank you sir!

[@rj3000ii]

Thanks for this video. Now I know I can do this. Much appreciated.

[@MrCaribe65]

Awesome. Thanks for making this video sir.

[@thatguyerk5426]

Pro tip: if the zerk is angled slightly make sure the grease fitting faces the driveshaft side not the axle/trans side. If installed towards trans/axle you cant fit a grease gun on it. Thats why mine went bad-prev owner minor mistake

[@Pippin8r]

What are the part numbers for the front and rear u-joints you used? I'm having a rough time finding the correct ones that fit my '66. 289, 4 STL, 9 inch rear.

[@AC-zo8ld]

Moog 498

[@Raulcane69]

BFH= Big Fuckin Hammer ? Good vid !

[@soldozer]

"Just give it the ole Tonya Harding" - Vice Grip Garage