Lucky all I get is a nice red screen all the time about a error saying panic wire ect an no fix too it as of yet. Congratulations on yours though an happy printing
Thanks! So far I'm happy with it. It's not without it's issues, but those will be fixed over time with firmware updates and me figuring out how to tweak my prints for the best possible results.
First problem: filament seal needed adjustment. Purge stip (front of the bed) was getting dragged back into the print. Finally, petg was not sticking to bed AT ALL. The purge tower was moving before the print had begun. Going to try a new roll of petg to see if it was a problem with the filament.
Lucky all I get is a nice red screen all the time about a error saying panic wire ect an no fix too it as of yet. Congratulations on yours though an happy printing
Congratulations on getting the new printer, hope it brings you all the joy & serves you well.
Thanks! So far I'm happy with it. It's not without it's issues, but those will be fixed over time with firmware updates and me figuring out how to tweak my prints for the best possible results.
at 29:58 , loading the filament. It would be good to show what you're doing. That's what I wanted to see. But you kept showing the control panel. :(
Tell it's printing quickly by the speed the spool turns :)
First problem: filament seal needed adjustment. Purge stip (front of the bed) was getting dragged back into the print. Finally, petg was not sticking to bed AT ALL. The purge tower was moving before the print had begun. Going to try a new roll of petg to see if it was a problem with the filament.