AutoCAD 3D Practice Drawing for Sweep Command | AutoCAD 3D Modeling Paper Clip & Cotter Pin Tutorial

[@ItsReeiiiii]

Correct me if I'm wrong but the paperclip measurement was off i think. The total width of the clip should be 10 because the diameter of the circle inside is 7 plus the 1.5 gap on both sides. anyway, your videos are helpful keep it up.

[@carlosjordan549]

GOODDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDD, i m from México, is very good

[@CADCAMTutorials]

Thank you 😊

[@einfachgil]

very welldone...keep it up sir

[@CADCAMTutorials]

Thank you, I will

[@suganthir8518]

I'm having doubt to calculate the paper pin... will u please explain the inner measurement calculation sir....