A must have

A must have @OnefinityCNC upgrade to explode possibilities!
In this video I show our new JTech laser.
Included in the video is instructions to set up the laser on a Onefinity black box controller. I also have instructions on setting up light burn for the Onefinity.
We do a test to verify or deny the ability to etch metal.
The results are showed in the video as well.
We have some awesome dark laser action you must see!
Carveco link
carv.eco/3IkbxWz
PWNCNC link
Https://pwncnc.com/?ref=D7STa4Rxeaj8P
‪@JTechPhotonics‬
​‪@OnefinityCNC‬

[@OnefinityCNC]

Good stuff! Keep up the great work!

[@Hinkleshop]

Thank you!

[@BuckysCustoms]

Very cool! It left me wanting MORE!!

[@Hinkleshop]

Thank you! That laser is awesome!

[@JohnColgan.]

04:20 I thought you were going to engrave the chips too!!

[@Hinkleshop]

Hahahaha 😆

[@JohnColgan.]

Even though the jtech has a sid3 shield. You & Mrs Ninja had safety specs. Mr Atlas or the Tearaway Terrier cant read safety instructions and Safety Specs dont fit them very well either.

[@Hinkleshop]

Glad you mentioned that,
other than when the camera was on I had put up a board to block the light from them
I should’ve put it in the video

[@wadetomczyk8043]

Wait a minute where have I been didn't you have a Shapeoko?

[@Hinkleshop]

I did but the guys at @onefinty sent me a machine they are awesome

[@wadetomczyk8043]

Nice. Thought about switching my Shapeoko out.@@Hinkleshop

[@Bart_Depestele]

Atlas looks a bit skinny, is he ok?

[@Hinkleshop]

Thank you for checking but he is good
He is free fed and has food available 24/7 he has always been on the thinner side though