Man, that’s about as un-safe as you can get!! It’s a wonder you haven’t lost fingers or even a hand. And if this is how you always operate that table saw, I guarantee you e been hit by a kickback! You have no business operating dangerous equipment!!
Beautiful design for the outside. It has no function however other than a giant paper weight. Cut the top off to make a lid, then hollow it out so you have form AND function. I’ve watched a few of your videos now and they are always paper weights. No functionality. I would buy it if it actually held something inside.
Great idea 💡, poor execution 😢. The piece isn't hollowed when it can be. Just driiling a hole down the center is considered poor quality. There's chip-out along the glue lines. Leaving the screw holes in the bottom from the faceplate is another sign of poor quailty. All these problems show you are lazy when it comes to creating something that can be outstanding, but you decide to take cheap shortcuts.
Beautiful work!
Thanks Very Much
Acho lindo seu trabalho, parabéns
That's a great machine
Bello !!!
Ottima idea !!!
Ottimo lavoro !!!
Thank You For Supporting The Channel
hoa văn tuyệt đẹp
cảm ơn bạn đã theo dõi và ủng hộ kênh của mình
Make your preview reflect the project next time
Man, that’s about as un-safe as you can get!! It’s a wonder you haven’t lost fingers or even a hand. And if this is how you always operate that table saw, I guarantee you e been hit by a kickback!
You have no business operating dangerous equipment!!
Thank You For Supporting The Channel
Beautiful design for the outside. It has no function however other than a giant paper weight. Cut the top off to make a lid, then hollow it out so you have form AND function. I’ve watched a few of your videos now and they are always paper weights. No functionality. I would buy it if it actually held something inside.
Thank You For Supporting The Channel
👍💖👍💕👍🎁
Thank You For Supporting The Channel
не в печетлила, нужна пустота в нем
Thank You For Supporting The Channel
Great idea 💡, poor execution 😢.
The piece isn't hollowed when it can be. Just driiling a hole down the center is considered poor quality.
There's chip-out along the glue lines.
Leaving the screw holes in the bottom from the faceplate is another sign of poor quailty.
All these problems show you are lazy when it comes to creating something that can be outstanding, but you decide to take cheap shortcuts.
so pra enfeitar. a mais nada
Thank You For Supporting The Channel
Beautiful work.