MillRight Carve King 2 CNC Setup and First Run

This is the MillRight Carve King 2 CNC machine. It is a powerful unit designed to custom cut through several material types. Today I finish getting the CNC setup and run my first project. There are two versions of the Carve King 2 One is the kit that you put together yourself and the other is a pre assembled kit. I recommend the unit that is already assembled because there are a lot of parts.
Please check out the MillRight CNC here on the official website:
millrightcnc.c...
SethCraft is a participant in the Amazon Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com

[@joeking433]

I think I'll buy this. I like to support American companies.

[@BrittCHelmsSr]

That is an awesome little CNC.

[@sethcraftworkshop]

There's been a bit of a learning curve but I'm thoroughly enjoying working on the CNC.

[@bopz.]

where do you get the material from? im new to this.

[@joeking433]

How much did they charge for putting it together?

[@adrianharrison5208]

I feel you could push that CNC a lot quicker than that 🙂 very nice machine

[@sethcraftworkshop]

I believe you're right. This is my first CNC machine. And I was just testing out its capabilities on a slower speed.

[@jim6402]

Thanks for the video how do you like mill craft cnc

[@sethcraftworkshop]

So far it has worked well. A little finicky on the lower part of the Z Threaded screw.

[@jim6402]

@@sethcraftworkshop
Thanks for the reply
I’m deciding what cnc I should get for entry level and software

[@joeking433]

Hmmm, seems maybe you would have been better off with the kit!

[@everlastingmedia]

$233 for 12 months of use. As a hobbyist, this is a bit over the top in terms of software subscriptions.... are there free or low-cost alts with a similar featureset?