Chevy Sonic/Cruze 1.8 P0443 EVAP Purge Valve - How to Replace PURGE VALVE (Step By Step)

Поделиться
HTML-код
  • Опубликовано: 28 авг 2024
  • In today's video I replace the Purge Valve on a Chevy Sonic 1.8. This fixed my P0443 code. NOTE that the code is not only caused by a bad purge valve.
    What causes the P0443 code?
    The ECM has commanded the purge control valve to open and detected either an incomplete open circuit or a short in the circuit.
    The cause of code P0443 can be a purge control valve internal open circuit or the connector is corroded causing loss of contact with the valve.
    The code can also be set if the wiring to the valve is damaged between the ECM and the purge valve causing an open circuit if the wire is cut or a short if the wire is shorted to ground or a power source.
    What are the symptoms of the P0443 code?
    The Check Engine Light will be illuminated and the code is set in ECM memory.
    You may notice a slight drop in fuel mileage if the vapor system is not working.
    How does a mechanic diagnose the P0443 code?
    Scans codes and documents the code in the ECM, views the freeze frame data see when the fault happened
    Inspects the entire vapor purge valve wiring and system to include the purge valve connector for corrosion, damaged or loose connection or wires
    Checks the purge valve vent for any blockage from dirt, debris, or spider webs
    Performs a smoke leakage test on the fuel vapor system to try and locate the cause of the vapor leak using the test vapor port
    Checks the purge control valve for proper resistance of valve and then check operation of valve using the ECM to control the valve
    Common mistakes when diagnosing the P0443 code
    Not checking and assuming the purge control valve is defective without doing a thorough diagnostics of the complete system to later find the wiring is broken or cut
    Not verifying the failure and replacing parts that may or may not be the problem
    How serious is the P0443 code?
    Code P0443 causes the check engine light to go on and this alone will cause a failed emission test.
    The code means the fuel vapor system control valve is defective or the circuit to it is not making the connection to the valve so the ECM lost control to the valve.
    The vapor recovery and reuse system if not working correctly can cause a loss of fuel mileage.
    What repairs can fix the P0443 code?
    Testing and replacing the purge control valve
    Repairing the damaged wiring to the purge control valve and secure from getting damaged again
    Replacing the purge vent valve

Комментарии • 9

  • @arielflores8607
    @arielflores8607 8 месяцев назад +1

    In step 4 when you say “slide the colored tab” what do you mean? Slide it out, forward? Which direction? I’m really struggling trying to get this last step disconnected

    • @vanpocalypse3529
      @vanpocalypse3529  8 месяцев назад

      Did you get it? Sorry I didn't see your comment right away.. I'd have to go back and see how it slides off; I don't remember.. but I can check for you if you need.

  • @tncarello
    @tncarello 9 месяцев назад

    The line with the blue clip... I was able to remove the blue clip but the line wouldn't come off. However I see a white plastic flexible tab inside. Is it just supposed to be pulled very hard or is there a step missing?

    • @vanpocalypse3529
      @vanpocalypse3529  9 месяцев назад

      I think I had to pull it pretty hard.. I don't remember specifically... were able to get it changed or still having issues?

    • @tncarello
      @tncarello 9 месяцев назад

      I was able to use two screwdrivers to try the white retainer up enough to slide the hose off. But it seems the new valve had some tolerance issues as the new hose would seal fine but wouldn’t lock back on securely. My dad suggested breaking the white retainer out of there and using a zip tie. As a former GM Mechanic he said sometimes dumb retainers like that had to be improvised.

  • @technician4053
    @technician4053 8 месяцев назад

    Geez man, can you keep the camera steady and show what you're doing?
    All I saw was a fuel line and a white tag.

  • @Emily-rs7je
    @Emily-rs7je Год назад

    What if I broke both blue clips? 🥲 I broke the retainer and the little blue clip from step 4 🥲 … so I could not get past step 3 basically and still cannot get the part out. And now I’m trying to look up where to buy the blue pieces but I can’t find out what they’re called 😢