Yes bro u r right about SAFETY, after about 5-6 flights, I've done the setup video, since I needed to test the setup by flying before presenting to audience. & everyone should setup his/her drone before attaching props. SAFETY ALWAYS COMES FIRST.
You can't get 100% stability with KK2.1 as per my experience...for 100% stability u'll have to use either DJI NAZA or PIXHAWK or Ardupilot APM controllers... You can experiment by changing transmitter trim buttons for hovering & other settings, if it works ☺️
please can you tell me how can i connect a Turnigy 9X 9Ch Mode 2 Transmitter w/ Module & iA8 Receiver CONNECT WITH KK2 1.5 ? hoc can i connect that transmitter
Bro how to land the drone like its perfecty taking off but I don't know how to land if i making throttle down its just falling straight how to safely land? Which buttons ?
Need help in Two things 1. The connection switch / socket / wire is overheating when battery is connected to the main PCB 2. Did everything you said. Drone is getting Armed but not flying. Help required
Check the connection properly For getting armed not flying 1) Low battery 2) Calibrate drone by placing it on level surface 3) Check motor rotation directions properly , two'll be clockwise & other two anticlockwise. 4) Try with a different battery Try these common troubleshooting techniques . If still problem persists let me know here..
@@SayanElectronics actually I am from rural area and there is no airport for about 100 km and I generally fly drone near lakes so will I required licence for that I have made drone for sky shots because dji is to expensive for me
It's always safe with a license , bychance if your drone go to a roadside .If you're flying in the rural fields where theres no one to get harm , then only it's safe..
Sir receiver test karte huwa samaye Mera aileron -98 left Elevator -no signal Throttle -no signal Rudder-no signal Auxillary -no signal Arm test - no signal Dekha ra hee
Generally It comes with the KK2.1.5 flight controller Here is the link - B12 HDP1206 Mini Active Buzzer on MakerBazar.in! makerbazar.in/products/b12-hdp1206-mini-active-buzzer
![ARGENTINA vs. PERÚ [1-0] | RESUMEN | ELIMINATORIAS SUDAMERICANAS | FECHA 12](http://i.ytimg.com/vi/xtI25ENDDSY/mqdefault.jpg)
Very brave
Setting up drone with propeller installed. And putting your finger between prop.
Having the drone powered with transmitter off
BASIC SAFETY
Yes bro u r right about SAFETY, after about 5-6 flights, I've done the setup video, since I needed to test the setup by flying before presenting to audience.
& everyone should setup his/her drone before attaching props. SAFETY ALWAYS COMES FIRST.
excellent demonstration thank you
Thanks a lot ☺️😇 , don't forget to share & subscribe
Which is the best battery for long time backup under 4000
Sir I need help I am facing problem of stability 😢
You can't get 100% stability with KK2.1 as per my experience...for 100% stability u'll have to use either DJI NAZA or PIXHAWK or Ardupilot APM controllers...
You can experiment by changing transmitter trim buttons for hovering & other settings, if it works ☺️
please can you tell me how can i connect a Turnigy 9X 9Ch Mode 2 Transmitter w/ Module & iA8 Receiver CONNECT WITH KK2 1.5 ? hoc can i connect that transmitter
Bro how to land the drone like its perfecty taking off but I don't know how to land if i making throttle down its just falling straight how to safely land? Which buttons ?
You'll have to practise that muscle memory to bring the throttle very slowly down for safe & slow landing..
Sir i am using the same thing and my motors go out of control before even picking up what can i do
Please do the transmitter settings like in this video..
ruclips.net/video/ETqUX74lOBY/видео.htmlsi=qWWWCsXINnIf_zuf
then ,try again
Sir can you tell how much flight time you got in this drone normal use
I didn't kept track but it was about 15minutes
Bro... KK2.1.5 board is not calibrating. Only message "Throttle pass-through". No beep sound. How to fix it?
Lower the throttle & try again just like I did in this video -
ruclips.net/video/ETqUX74lOBY/видео.htmlsi=NhhSXiNDlQzCuJYt
@@SayanElectronics sorry.... I am using a flysky ct6b transmitter
Need help in Two things
1. The connection switch / socket / wire is overheating when battery is connected to the main PCB
2. Did everything you said. Drone is getting Armed but not flying.
Help required
Check the connection properly
For getting armed not flying
1) Low battery
2) Calibrate drone by placing it on level surface
3) Check motor rotation directions properly , two'll be clockwise & other two anticlockwise.
4) Try with a different battery
Try these common troubleshooting techniques . If still problem persists let me know here..
Does amp 2.8 support gimble and gps
APM 2.8 flight controller supports gps
@@SayanElectronics but I am just making for fly so should I buy amp for kk215
Super guru 🙌
Thanks a lot ❤😊🙏 Your positive comments inspires to make more quality videos
لطفا زیرنویس انگلیسی بزارید تا ما هم متوجه بشیم💫🌹
Bro do I required licence for homemade drone
If you are flying it in a public place ,obviously you've to get licensed or else you'll get fined
@@SayanElectronics actually I am from rural area and there is no airport for about 100 km and I generally fly drone near lakes so will I required licence for that
I have made drone for sky shots because dji is to expensive for me
It's always safe with a license , bychance if your drone go to a roadside .If you're flying in the rural fields where theres no one to get harm , then only it's safe..
Kya kk2.12 me gps laga sakte hai
Nahi vai
Is me cemara kaise lagaye
Thank you for this comment. I'll make a video on it☺️
Bro iam facing a problem of transmitter not connecting to reciever 😢😢 please reply
😊
Jodd ❤️🔥
Thank you❤😀
Sera
Thanks bro
The cut on your finger is visible, still you are drone with your finger between props
Hi brother my drone is not flying up only what to do?
Recheck all connections also make sure proper voltage is going to both transmitter & receiver
Ok
bro maine sab same kiya, step by step, still ye flight nhi le rha
Transmitter FSi6 programming vi thikse hona chahiye vai , to take off for flight..
Hello bro mere esc me problem aa raha hai 😢
Please explain about what problem u are facing...
Sir receiver test karte huwa samaye Mera aileron -98 left
Elevator -no signal
Throttle -no signal
Rudder-no signal
Auxillary -no signal
Arm test - no signal
Dekha ra hee
wire k connections check kar lo ek baar
pal, what is this part called? 8:02
It's the "Buzzer" bro
@@SayanElectronics where can i buy ? do you have link bro ☺️
its that a necessary? or an optional
Generally It comes with the KK2.1.5 flight controller
Here is the link -
B12 HDP1206 Mini Active Buzzer on MakerBazar.in! makerbazar.in/products/b12-hdp1206-mini-active-buzzer
It gives low battery indication ,which is much important before taking off / during flight
Bro kk flight controller is blank and no text
Try this -
www.flyrobo.in/blog/how-to-solve-kk-flight-controller-blank-screen-problem