Review of an Atezr L2 Laser Engraver. Engraving, Cutting and IC Marking Removal

In this video, I reviewed an Atezr L2 laser engraver. This is Atezr’s recently released second generation laser engraver. It boasts an engraving speed of up to 54,000mm/min and has an working area of 410mm X 410mm. Product link: bit.ly/3OZOC7F
Other Atezr products: shln.top/jvW2OurO
Atezr Amazon store: www.amazon.com/ATEZR-Laser-En...
00:00 Overview
01:18 Assembly, setup, air assist
05:27 Powering up, handheld controller
09:04 Focusing, custom button setup in LaserGRBL
12:06 Test patterns
14:32 Cutting tests
17:40 Engraving tests
20:23 Laser etching, IC marking removal, final thoughts

[@chuckvoss9344]

very nice review. will have to look into this one. tks

[@donalddunn2983]

Can you tell me how to turn that cross hair on and off? Mine does not come on and I need to know if it's a problem with the machine or if something got turned off some how?

[@irekdz]

Thanks for the review. Is it possible to cut aluminium sheets wit this machine? For example 1-2mm alu sheet?

[@KerryWongBlog]

Hi Irek, blue diode laser unfortunately is not suitable for sheet aluminum cutting. It will cut through 1-2mm stainless steel and there are videos on youtube demonstrating that.

[@darrellreed7044]

How do I get it connected to my wifi?

[@eddiec1960]

My laser module does not fit! I can't get it to slide on as yours does in your video. Everything looks the same as yours but I can't get the laser module installed!

[@KerryWongBlog]

Did you loosen the thumb screws on the right side? There are two of them.

[@pchunter168]

😀