Can you tell me how to turn that cross hair on and off? Mine does not come on and I need to know if it's a problem with the machine or if something got turned off some how?
Mine have always been on. I don’t find the crosshairs very useful though. The horizontal one is in line with the laser, but the vertical line is useless. It could be a loose wire in the harness not sending power to the crosshairs. Not sure.
@@SouthpawWorkshop I have seen the RUclips that shows you how to line up the laser to the cross hairs. You first burn the cross from the touch pad and then you jog the lasers X and Y until your laser lines up perfectly with the cross it burned. I can't try that because My cross hair is not on.
@@SouthpawWorkshop It might be a loose wire but I checked all of them and they seem secure. Atezr sent me an instant massage yesterday telling me that you can turn the cross hairs off and on as follows:. __The product manual should provide an explanation for the cross red light. You can take a look. It can be turned off in the corresponding settings.__I asked where those setting are and they sent this back__:If you don't know how to operate it. We will help you contact the factory to inquire if there are specific operation videos for your reference.__ Typical no real answer from them.
All I could find about crosshairs settings was in this Reddit post. Keep in mind that this is assuming you are using lightburn: www.reddit.com/r/xToolD1/s/YVu8LKkwAK
Got mine for 50% off!!! 😁
How did you get such a great deal?
Can you tell me how to turn that cross hair on and off? Mine does not come on and I need to know if it's a problem with the machine or if something got turned off some how?
Mine have always been on. I don’t find the crosshairs very useful though. The horizontal one is in line with the laser, but the vertical line is useless. It could be a loose wire in the harness not sending power to the crosshairs. Not sure.
@@SouthpawWorkshop I have seen the RUclips that shows you how to line up the laser to the cross hairs. You first burn the cross from the touch pad and then you jog the lasers X and Y until your laser lines up perfectly with the cross it burned. I can't try that because My cross hair is not on.
@@SouthpawWorkshop It might be a loose wire but I checked all of them and they seem secure. Atezr sent me an instant massage yesterday telling me that you can turn the cross hairs off and on as follows:. __The product manual should provide an explanation for the cross red light. You can take a look. It can be turned off in the corresponding settings.__I asked where those setting are and they sent this back__:If you don't know how to operate it. We will help you contact the factory to inquire if there are specific operation videos for your reference.__ Typical no real answer from them.
All I could find about crosshairs settings was in this Reddit post. Keep in mind that this is assuming you are using lightburn:
www.reddit.com/r/xToolD1/s/YVu8LKkwAK
from what i'm been seeing the performance of this lasers at the same power are pretty similar
but why don't you say the setting parameters..?😴