It should be the same as this video. If you are not getting any stick movements, you may need to check the UART tab and Receiver protocol (CRSF) in the configurator.
got the same problem with my receiver and taranis but i did the emergency reset but nothing happens. After the reset the receiver return into the binding mode. The Controller dont wanne connect
1) Check your solder RX & TX (RX goes to TX & TX goes to RX) 2) To my recollection, the frsky radios need to have a mod on them for CRSF to work, please double check that 3) If you are using a quad, make sure the ports tab is active on the correct UART and the receiver protocol is correct on betaflight
Saved my time. Tnx.
simple and strait forward. thanks!
This worked with my Tango 2! thank you so much!
Thank you for this quickly fixed my issue
Could you do a video connect TBS Crossfire Diversity Nano RX with speedybee f405 wing?
It should be the same as this video. If you are not getting any stick movements, you may need to check the UART tab and Receiver protocol (CRSF) in the configurator.
Huuuge thanks for reset option!
Super merci beaucoup !!!
nice vid bro. tnx
got the same problem with my receiver and taranis but i did the emergency reset but nothing happens. After the reset the receiver return into the binding mode. The Controller dont wanne connect
1) Check your solder RX & TX (RX goes to TX & TX goes to RX)
2) To my recollection, the frsky radios need to have a mod on them for CRSF to work, please double check that
3) If you are using a quad, make sure the ports tab is active on the correct UART and the receiver protocol is correct on betaflight
double blinking red light never changes to flashing once i hold it mannn any ideas ?
hmm, no idea but TBS support is very helpful, I would try to contac them.
Thanks a lot!
it WORKS!! 😃
Thanks !!
The light blinks green and the drone beeps, I engage the binding process on my tbs tango 2, then the drone light turns red and nothing happens
if you want a few seconds, your radio will ask if you would like to update the receiver. Go ahead and update it and it should be green.
@@IRONQUAD I did that but after updating, nothing happen, the led on the rx is full green but the radio is still in in bind mode
@@baptistebouvat6189 Please repeat the process until the light is red when asked to update the FW
Could you do the same videos but with tbs tango 2 plis?
reset the receiver then press and hold the "menu" button. you can access the CRSF settings from there to bind
Ça ne fonctionne pas je comprend pas
Спасибо а то я уже поза...бался