we got our uplander back after a new rack and pin replacement. it started and we got it home. Started it the next day and nothing. Thank you for this!!
Thank you for the information I have a 205 with the same problem I'm putting a battery in first to see if it's going dead because the alarm doesn't work either but that is good to know another piece of research another piece of information very valuable thank you for this video
Hi , I have exactley the same problem my car wont start , so what i understand is I have to increase the power of the ground cable for the engine ? ???
Usually when this happens is because your not using the actual key that has that code on it. Try using the original in not leaving the key in turn it Accessory and let it sit for exactly 10 minutes switch it off and then start it should work
They say if you don't have anything good to say then don't say it at all. This video suck. Why not fix the issue and not jumper wires and bring the value of the vehicle down.
we got our uplander back after a new rack and pin replacement. it started and we got it home. Started it the next day and nothing. Thank you for this!!
right on, I am helping a buddy tommorrow, and this is awsome help in fixing the issue with his car, t hank you very much.
Great video I have been tapping on my starter for a few months but I think it’s finnaly done at least the weather is not freezing to walk to work 😊
Thanks
Do I put the ground wire to the engine and the battery or the car body thanks good viedo
Thank you for the information I have a 205 with the same problem I'm putting a battery in first to see if it's going dead because the alarm doesn't work either but that is good to know another piece of research another piece of information very valuable thank you for this video
What wasn’t shown was him replacing the bad relay cause the ground wire to the engine was not the problem.
Excellent video brother!!
مرحبا صديقي - انا من العراق و عندي نفس نوع السيارة ...هل من الممكن رابط شراء ذلك الفاحص ؟ و هل هو موجود في سوق علي اكسبريس ؟ شكرا لك
Hi , I have exactley the same problem my car wont start , so what i understand is I have to increase the power of the ground cable for the engine ? ???
omar alsalhi Check ignition relay ground..!
What a cranky service failure . for 2006 uplander 3.5 moter..LS ...2front wheel is that a sensor or a key problem...
Brother my car is same problem please help me
Hi bro,I have starting disabled light in my uplander 05,how can I fix it please?thanks
Vincent Mukendi did you figure out the problem?I got the same issue with my friends car
Usually when this happens is because your not using the actual key that has that code on it. Try using the original in not leaving the key in turn it Accessory and let it sit for exactly 10 minutes switch it off and then start it should work
They say if you don't have anything good to say then don't say it at all. This video suck. Why not fix the issue and not jumper wires and bring the value of the vehicle down.