Thanks, i have a bosch 3725devs, and it looks exactly the same, and will be replacing the bearings - couldn't figure out how to get to the lower bearing without this video.
Is there any way to press the final bearing out pr back in after replacing without a bearing press? Would like to replace this part but don't have that machine
Thank you so much for your video on how to replace bearings on a Bosch GEX 150 orbital sander
Glad to help
Thanks, i have a bosch 3725devs, and it looks exactly the same, and will be replacing the bearings - couldn't figure out how to get to the lower bearing without this video.
This is the video I was looking for. I couldn't figure out how to remove the rotor from the plastic housing. Twist clockwise !
Thanks
So that's how you do it! I am very grateful for this video.
Great video - exactly my issue. Thanks
great vid thanks any ideas my base stays on for few minutes then comes loose tried new base but same.
Ótimo vídeo👍👍
Nice one mate, definitely worth it then 👍
Doesn't it make a difference if you swap 1 needle bearing for 2 ball bearings? I like the Idea. Nice Job.
Full repairing course Boss sending machine
well done
Dean how do we remove the top armature bearing? Cant tell what tool fits in that tiny hole that holds the bearing in place
Is there any way to press the final bearing out pr back in after replacing without a bearing press? Would like to replace this part but don't have that machine
Where did you get the switch I cant find it online!?
👍👍