Hi, what specific tool did you use to clean the hot end and get out the excess filament after the nozzle was removed? I’ve tried some tools and they aren’t working as well.
Does heating up the nozzle prevent you from snapping the nozzle off? My friend was saying he had trouble changing the nozzles. He kept snapping them off.
Hi, I went to connect the uno to the board to set the BL touch up. And on my board I have 4 pins in a row and not 6 pin set up. I have an Ender 3 not the pro. Any suggestions? The 4 pins are VCC, SWDIO, SWCLK AND GND.
I hope you found this overview helpful! If you have any questions or would like other tips/tricks, just let me know in the comments.
Hi, what specific tool did you use to clean the hot end and get out the excess filament after the nozzle was removed? I’ve tried some tools and they aren’t working as well.
Hi. I use a nozzle cleaning kit. I have a video covering it that you can see here. ruclips.net/video/Ls71JwnHHvI/видео.html
Does heating up the nozzle prevent you from snapping the nozzle off?
My friend was saying he had trouble changing the nozzles. He kept snapping them off.
Hi. Ya, the metal expands when heated. If you don’t heat the hotend, the nozzle can snap easily.
Hi, I went to connect the uno to the board to set the BL touch up. And on my board I have 4 pins in a row and not 6 pin set up. I have an Ender 3 not the pro. Any suggestions? The 4 pins are VCC, SWDIO, SWCLK AND GND.
Hi. Do you have the Ender 3 or Ender 3 V2? I’m pretty sure the board was changed on the V2.
Ender 3
Can you email me a picture of the board, I will try to take a look at it tomorrow. My email is admin@3dprintscape.com.
Done! Thanks
Was your nozzle opening the original, .5 mm?
Hi. Ya it was .5mm.