My current mods are 1. k and n cold air intake 2. Headers American racing to full straight pipe 3. Ported stock throttle body 4. Weight reduction back seats trunk everything gone but battery ofc, removed washer fluid res blocking my air intake 4. Lowered on bmr lowering springs 5. Front strut bar 6. Tuned by hp tuners at 373 hp 342 trq only cause tuner is special ;) 7. Indy 500 on the rear a/s on the front
My Mods On My Car Is 1.Cold Air Intake 2. Jacfab Manifold Spacer 3. Ported Manifold 4. Ported throttle Body 5 Catless Downpipes From ARH 6. Exhaust 7. tune
The spacer is a great addition to the car, sadly it would be hard for me to make a tutorial on it because I already have it installed but I’ll have more one the way on different parts
@@oakleystanley81 I seen a video on install but it was a 2010..is install same as like the 2010?…take the cover, take screws off manifold, lift the manifold up and goes under it
Lol so some of them out there walk or run with coyotes. I have a 6th gen V6 Camaro, FBO and e85, tune. It was 335 hp and 13.6 quarter mile stock. Newer gen Coyotes are my closest runs besides the scats
My current mods are
1. k and n cold air intake
2. Headers American racing to full straight pipe
3. Ported stock throttle body
4. Weight reduction back seats trunk everything gone but battery ofc, removed washer fluid res blocking my air intake
4. Lowered on bmr lowering springs
5. Front strut bar
6. Tuned by hp tuners at 373 hp 342 trq only cause tuner is special ;)
7. Indy 500 on the rear a/s on the front
Who’s your tuner ?!?
My Mods On My Car Is
1.Cold Air Intake
2. Jacfab Manifold Spacer
3. Ported Manifold
4. Ported throttle Body
5 Catless Downpipes From ARH
6. Exhaust
7. tune
Nice, what kind of powers do you think it makes crank.
@@oakleystanley81 most likely around 380-390 ish
@@MaroVillain that’s great
My current mods is
1.k&n intake
2. Trifecta tune
I’m ready to put the manifold spacer on can you make more depth tutorial and review on it?
The spacer is a great addition to the car, sadly it would be hard for me to make a tutorial on it because I already have it installed but I’ll have more one the way on different parts
@@oakleystanley81 it’s fine thanks tho
@@ExoTicTrelly if I ever have it if I’ll be sure to make one on it
@@oakleystanley81 I seen a video on install but it was a 2010..is install same as like the 2010?…take the cover, take screws off manifold, lift the manifold up and goes under it
There very similar installs
Great vid! How about a tune also?
Top 5 mods:
1. Coyote swap
2. ^
3. ^
4. ^
5. ^
Just kidding, that’s a good lookin car buddy!
Hum 😳 not a bad idea lol. Coyote Camaro
Lol so some of them out there walk or run with coyotes. I have a 6th gen V6 Camaro, FBO and e85, tune. It was 335 hp and 13.6 quarter mile stock. Newer gen Coyotes are my closest runs besides the scats
Do you mean Camaro 2SS/RS?