How to Replace High Mount Third Brake Light 2006-2011 Cadillac DTS

Buy Now!
New High Mount Third Brake Light from 1AAuto.com trq.video/ia-G...
This video shows you how to replace the high mount third brake light on your 2006-2011 Cadillac DTS. The third brake light is just as important as your other tail lights. In many cases, a broken or burnt out third brake light alone can fail a safety inspection. Avoid problems and increase safety by replacing your third brake light assembly with one from TRQ designed to fit your specific vehicle.
This repair was done on a 2010 Cadillac DTS Platinum 4.6L and the process should be similar on the following vehicles:
2006 Cadillac DTS
2007 Cadillac DTS
2008 Cadillac DTS
2009 Cadillac DTS
2010 Cadillac DTS
2011 Cadillac DTS
Tools you will need:
• Flat Blade Screwdriver trq.video/oarW...
• 10mm Socket trq.video/oafL...
• Trim Tool Set trq.video/oDt-...
• Push Pin Pliers
• Ratchet trq.video/oaAd...
Subscribe: / @trq
Check out our playlist:
Cadillac DTS 2006-2011 1st Generation: • Cadillac DTS 2006-2011...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money

[@dstarj1]

Nice job, and thanks for the video. My 2007 DTS failed the safety inspection for this very light. Was cracked and les than 70 % lights on. Will get part tomorrow. Again, this was a lot of help.

[@williambissell5943]

did you put a new one on or did you put a replacement light in?:?

[@stevereyes7674]

Does the full light need to be replaced? 9:20 pm

[@malcomhutchinson7727]

Can you use the same push pins

[@malcomhutchinson7727]

Where can you get the tool for that cover

[@joepaul1763]

The light is so freaking expensive

[@madddads6418]

Bad explanation