pl162t water level probe problem- steam boiler overfilling

[@davidengel7321]

Thank you for this video. I had the issue with the probe that it was inside the plastic. Now my Bianca is fixed with no money spent!

[@note2you]

thanks for share

[@achitofernandez2570]

I heard that the problem full boiler... is a usually problem in MaraX...
few friends have the problem... the waranty change the machine

[@ShalevAbuhatzeira]

What is the PN for the Mara X / Bianca water level probe gasket which come somtimes in white or green foam metarial? I need to replace it in my bianca.

[@lelitinsider2977]

teflon gasket (white) for the water level probe

[@ShalevAbuhatzeira]

@@lelitinsider2977 thanks. Which diameter and thikness?

[@lelitinsider2977]

@@ShalevAbuhatzeira 13x17 h 2.5mm, or use some teflon tape, it works

[@ekinnyc]

Is there a way to drain the steam boiler without turning the machine over? I had this issue, fixed by replacing the level sensor. Was fine, until I drained the service boiler by opening the hot water tap, then when I added new water, I have this problem again

[@lelitinsider2977]

hi, with bianca , if you drain the water from the water tap, you remove complitely the water, look the boiler inside ruclips.net/video/H7eh289nUh4/видео.html

[@lelitinsider2977]

how old is your machine? if you need help , to be faster please send a video at [e-mail]

[@hariswiranata9894]

My bianca only reach 2 bar and water debit from screen/head only flow out a bit. What is the problem?

[@lelitinsider2977]

there may be dirt in the flow control, contact your dealer or email [e-mail] for more information.

[@pilosopo25]

Where can I buy that water level probe?

[@lelitinsider2977]

from your reseller in your country! or ylu have to look for a reseller lelit