Orion Motor Tech and Maddox Front Wheel Bearing Adapter tool Kits, Amazon/ Harbor freight, Review
HTML-код
- Опубликовано: 4 окт 2024
- Side by side review and Compare
Orion motor tech 23-piece FWD front wheel drive bearing adapters puller press replacement installer removal tool kit
MADDOX superior automotive tools
Front Wheel bearing Adapters (MC21-1)
#Q. What Tools to Remove and Reinstall a wheel Bearing?
#. Thank you for your time watching this video I hope it helps you out and buy yours
I bought the harbor freight tool for hub bearing on a 96 maxima .The bearing was putting up a fight coming out so I put an impact gun on it .Stripped the threads right off the jack bolt ..took it back to horborfreight and they exchanged the whole tool out no questions asked ..The new tool I used a wrench and Rachet and it worked out fine
Yes most of the time if you put too much stress on it, it will strip or break I'm glad you got it exchanged
Good comparison- thanks ! ! !
thank you for doing this video.
You're welcome
Helpful video. Thank you for doing this 👍
Thanks for watching and for visiting my channel
Thanks for making this video, it helped me out
You welcome bro
Thanks
I bought the motor tech and I could not get it to work on a 2018 Honda HRV the bearing came out but would not go in it went in for a little bit of time and then it stopped I got it tighten and then all of a sudden she just dropped and got loosen so I don't know if it was me or the tool
It could be you, most of the time start the job by tabbing it with a rubber hammer after that and make sure its totally even or straight. But other than could be the difference in 2018 Honda
I think I got 2 videos where I was using this tool you can check that out and see if It helps, thanks for watching and visiting ish MOTORPARTS
@@IshMotorparts the one I got was 75 bucks on Amazon it was the motor tech maybe it was me maybe it was the bearing I don't know because when I bring it to Mavis they pushed it in so quickly
Yes it could be Bearing itself you have wrong one or Damaged Hub/ bearing housing, or you using the wrong piece of tool
@@IshMotorparts no nothing was wrong with the bearing or the hub or the knuckle I gave it to Mavis and they pressed it right in with no problems I think maybe I was scared to give it Force I don't know but I'm going to give it another shot on my Toyota
Como iconos ese puler
Can I use this tool to remove and install the hub?
Yes you can, it's made for remove and Install
@@IshMotorparts so it’s for the hub and also the bearings?
@manuelsalgado8510
Yes it's for removing the Bearing from inside of the Hub or knuckle
@manuelsalgado8510 and push it back the New one in
Get a hub grappler otc
Will these work for Mercedes?
Not very sure, But according TO the handbook
MERCEDES ITS NOT INCLUDED, SORRY
Ish Motorparts ok thanks
@@IshMotorparts I know that this is an old comment, but with what I saw in this video, it's very clear that this tiny paper could not possibly contain info for all vehicles.
it's too bad that they didn't create more of a style type guide.
Like, if your wheel assembly looks like this, do this.
If it looks like (other picture) do that... and so one.
More research is necessary.
Thumbs down for blowing my ear up at the beginning of this video! I had to stop the video at that point! ANNOYING
Sorry I didn't know that I will look at it thank you for letting me know
M.A.G A
LMAO I enjoyed the intro music ¯\_(ツ)_/¯
All i seen and heard is pretty much shit, he didn't fit nothing, all he did is mumble # 1 ... #2 ...pick tis up , pick that up. Man your video explains F.... all