Mini Ikea Dollhouses on the Bambu X1C with AMS!

Ways to Support TADA3DPrinting -
Prusa Affiliate Link -
By purchasing with this link, it helps out my channel at no cost to you
www.prusa3d.com...
My Etsy Store -
www.etsy.com/s...
Become a member of TADA3DPrinting & get access to perks:
/ @tada3dprinting
Support this channel by purchasing merchandise - tada3dprinting...
Visit my Amazon Storefront - amzn.to/3Pxu31X
Need to contact me directly?
[e-mail]

[@BennyTygohome]

She's back!

[@Barbasnoo]

Wonderful to have you back!

[@tada3dprinting]

Thanks for watching!

[@zwei.r]

Sorry for your loss! It’s great to see you are back. For the small one and even for the bigger house I would suggest looking into smaller Nozzle sizes. For the small one, it seems to me from the video, that the bed adhesion was not enough - maybe try glue? The smaller one also seems like SLS printer territory to me.

[@tada3dprinting]

Yeah and I may need to make the walls thicker. Maybe just scaling down so much was a little too drastic. Thanks so much!

[@brycejeannotte7699]

Those are cute. I have found that when things get really small Bambu slicer seems to just "loose" details. On my A1 mini I swap out the 0.4 nozzle for the 0.2 nozzle and it does a great job. It will be interesting to see your furniture for the 1/144 scale house. 😃

[@tada3dprinting]

Oh yeah that would be good timing to try that out! I think I have one. Thanks!

[@woodwaker1]

You could try the larger scale on the Prusa XL, would be curious what scale you could print on it.

[@tada3dprinting]

Yeah I am getting really close to trying out different nozzles on it again. Thank you!

[@scifimodelshop]

I would try that really small one on the Prusa MMU these printers seem to handle really small prints well

[@tada3dprinting]

Yes that's a good point. Thanks!

[@The3DPrintingGrandad]

What filament did you you use for the wood?

[@tada3dprinting]

It's Sunlu in Burly Wood - amzn.to/3wBAtGY

[@kurtstrains]

Really great video! I print a lot of model train stuff at 1:87 scale. I have some suggestions for you:
1 to fix the little gaps, try increasing your extrusion multiplier a few percent.
2 I find that making the separate colors in your design software and saving a file for each color is way easier then coloring the model in the slicer.
3 I swapped out my old mk3 nozzle from .4 to .25 and it makes small details WAY better.
4 check out my channel I have lots of 3d printed content :)

[@tada3dprinting]

Thanks for the tips! I'll check it out!