thanks, I wanted to make this as simple as possible, so that it is easy to understand. I don't like going to a video for help, and the video doesn't get to the point, it drones on and on, or gets too artsy with lots of edits.
I am a bit confused, the wires under the switch (There are two correct?) where are the soldered? One from the green Switch Motor wire and the other from the Yellow one (Yours White) to the underside of the rails? the other ends to the Sw motor.
if you go to 2 minute 2 seconds and pause the video, i have a pointer on the rail that i soldered the green wire, the white/yellow is soldered to the rail just below the pointer, if you need me to i just got a new ross switch i haven't put on the track yet, and can make a you tube short video.
thanks I got it to work on my bench but of course when I went to do one on the layout it didn't work. Back to the drawing board. IF I have to I'll call Steve Ross unless you can do a short like you said. Thank you, Pat @@ganrailroad
Thanks i saw the short video & I noticed you had insulated pins on both outside rails. I only had them on the two with soldered wires. I'll try n see if this helps Thanks, Pat
Absolutely the best RUclips Video I have found to properly wire a Ross Custom Switch with a non-derailing configuration
thanks, I wanted to make this as simple as possible, so that it is easy to understand. I don't like going to a video for help, and the video doesn't get to the point, it drones on and on, or gets too artsy with lots of edits.
Thank you for doing this. Building my first layout. Have Ross switches. This is very helpful and the most informative
I am a bit confused, the wires under the switch (There are two correct?) where are the soldered? One from the green Switch Motor wire and the other from the Yellow one (Yours White) to the underside of the rails? the other ends to the Sw motor.
if you go to 2 minute 2 seconds and pause the video, i have a pointer on the rail that i soldered the green wire, the white/yellow is soldered to the rail just below the pointer, if you need me to i just got a new ross switch i haven't put on the track yet, and can make a you tube short video.
thanks I got it to work on my bench but of course when I went to do one on the layout it didn't work. Back to the drawing board. IF I have to I'll call Steve Ross unless you can do a short like you said.
Thank you,
Pat @@ganrailroad
Thanks i saw the short video & I noticed you had insulated pins on both outside rails. I only had them on the two with soldered wires. I'll try n see if this helps
Thanks,
Pat